Parts for Maytag MVWB725BW0: 02 - Control Panel Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Fix water overflowing from dispensers or leaking behind your washer. This inlet valve controls water flow into the tub. Easy 30-minute DIY repair.

Replacement control knob for dryers and washers. Installs on the control panel to adjust settings. Replace worn, broken, or missing knobs for reliable use.

This main control board is the electronic brain of your washing machine that controls all wash cycles, water levels, and motor functions. It receives input from user controls and sensors to manage the entire wash process. Replace if cycles don't start, stop mid-cycle, or if the washer doesn't respond to control inputs.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Screw for control panel.

Hex nut secures panels and components in your washer. Replace if missing, stripped, or corroded to restore proper assembly and stability during use.

This is a replacement screw designed to work with a wide range of household appliances. It is used for many purposes in these appliances, from holding body panels together to securing electronics into control boards. However, screws are subject to damage through corrosion, impact, and improper installation/removal. In most cases, the primary damage to this screw is through corrosion – it may become rusted or corroded in place, depending on the appliance and the maintenance provided during its lifespan. The screw may also be stripped or rounded due to improper removal or installation. If the screw is damaged, lost, or corroded in place, it will need to be replaced. In most cases, removal will require nothing more than a Phillips head screwdriver or the appropriately sized socket with a ratchet. However, if the screw is damaged, it may require a tap set to remove it from its mounting location. Note that this is a genuine OEM replacement screw made from durable, high-quality metal, and is sold individually. It fits Whirlpool, Maytag, Roper, Estate, Amana, Crosley, and Thermador appliances. It is used in over 150 machines, ranging from washers and dryers to air conditioners.

Replacement mounting screw for laundry center panels and brackets. Needed when original fastener is lost, stripped, or damaged during service work.

This factory screw secures panels, brackets, and other components in your appliance. Replace a missing, stripped, or corroded fastener to restore a tight fit and keep parts properly aligned and rattle-free.

• Secures appliance components and panels in their mounting points
• Replaces damaged, stripped, or missing hardware
• Helps reduce rattling or vibration from loose parts

• Disconnect power; shut off water or gas supplies if applicable
• Match location with the original screw; start threads by hand to avoid cross-threading
• Tighten until snug; do not over-torque, especially into plastic or thin metal
• Reinstall any covers or panels and test for secure fit

Replacement power cord for washers. Installs at the rear panel to restore electrical connection. Replace if damaged, frayed, or missing.

Size: 10-24 x 3/8 inch.

Fix intermittent electrical issues or damaged connectors in your washer. This 6-coil wire harness restores power and signal routing between components.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.