Parts for Jenn-Air JES8750BAS: 02 - Control Panel / Top Asy Parts

If your large burner won't heat or stay at the right temperature, the element switch likely needs replacement. Simple 10-15 minute repair with a screwdriver.

Burner won't turn off or only heats on high? This infinite switch controls heat settings for your electric range's surface element. DIY repair.

Indicator light that illuminates when functions are active on your range control panel. Replace if stuck on, dim, or fails to light. Verify fit by model number.

To order indicator light use WP903115.

Replacement control knob for range burners. Installs on the control shaft to adjust heat levels. Replace if cracked, broken, markings worn off, or missing.

This electronic control board manages the appliance's cycle selection, timing, and user interface so your machine runs the settings you choose. Replace a faulty board to restore responsive controls and normal cycle operation. What it does:

• Receives and processes user inputs from the console and sends commands to motors, valves, heaters, and sensors
• Controls cycle timing, cycle selection, and start/stop functions
• Communicates error conditions to the display or control panel
• Common symptoms of a failing board: unresponsive or blank controls, cycles that won't start or complete, incorrect cycle behavior, or persistent error codes

• Disconnect power to the appliance before starting any repair
• Handle the board by its edges and avoid static discharge; use anti-static precautions if available
• Verify the board PN on the old part matches WP8507P225-60 before installing

Sheet metal pan head screw secures panels, brackets, and components to appliance cabinets. Replace missing, stripped, or corroded screws to restore fit.

Replace your cracked, broken, or worn range control knob. Push-on design installs on the control switch shaft. Restores full functionality to your cooktop.

Burner not heating or 'Hot Surface' light stays on? This electric cooktop surface element is likely the fix. DIY-friendly, most installs take 15 minutes.

The Large Surface Element is an OEM component for Whirlpool ranges. As a key heat source, it withstands significant thermal stresses each use for cooking tasks. This surface element measures approximately 10” in diameter.

Over time, microfractures may accumulate in the ceramic glass from repetitive heating/cooling cycles. Mineral deposits also build up on the surface, reducing heat transfer effectiveness.

Symptoms involve:

• Inconsistent or diminished heat from the designated zone 
• Noticeable cracks, clouding or chips in the glass material
• Safety hazards if integrity is lost, exposing electrical/gas

The element is compatible also for select KitchenAid and Maytag appliances.

Replace your worn, cracked, or missing range control knob to restore precise operation of front panel settings. Attaches to the control shaft for smooth adjustment.

This is a replacement screw used to secure panels and components on compatible Whirlpool appliances, sold as a pack to replace multiple fasteners at once. It provides a simple way to restore missing or worn screws and stop rattles or loose trim. What it does

• Fastens appliance panels, trim, brackets or internal components
• Restores proper fit where screws are missing or corroded
• Helps eliminate vibration noise and loose parts
• Matches OEM fit for the listed part number when used in the intended locations

• Use the correct screwdriver or nut driver to avoid stripping the head
• Keep screws organized and install only where the OEM diagram specifies
• Disconnect power and follow appliance safety procedures before servicing
• Wear safety glasses and avoid over-tightening to prevent damage

Fix a burner that won't heat with this surface heating element. Restores even cooking on electric cooktops. Standard drop-in style for many models.

Replace a non-heating warming zone on your electric range. This element restores low-heat functionality to keep food warm. Basic DIY repair.