Need Help?
Call or text
Show parts
The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells. This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.
This part is discontinued by the manufacturer and is no longer available for purchase.
Replacement end cap for washer left-side assembly. Secures cabinet alignment and protects internal components. Needed when original is cracked or missing.
Usually ships within 4 - 14 days
Right-side cabinet end cap for washers. Replaces cracked, broken, or missing trim piece. Restores proper fit and protects internal components.
The Pressure Switch is an OEM replacement part for GE washing machines. It's responsible for monitoring the water level inside the wash tub. By signaling the washing machine to start and stop filling with water, it ensures the appropriate water level is maintained for each specific wash cycle. Symptoms of a bad Pressure Switch include:
The typical causes for a malfunctioning Pressure Switch can be a result of mechanical wear over time, a defect in the pressure hose leading to incorrect readings, or electrical failures that affect the switch’s ability to communicate with the rest of the washing machine. This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
Replace your washer's control panel button if it's cracked, broken, or missing. This snap-in component installs on the control panel face plate.
Replace your worn, cracked, or missing washer control knob assembly. Restores secure grip and clear position indicators for cycle and temperature selection.
The Probe Sensor (ATC) is an OEM replacement part for GE washers. It plays a key role in monitoring water levels and temperatures during cycles. Symptoms of a bad probe sensor include:
Causes can include normal wear over time as the delicate internal components are subjected to constant temperature changes and immersion in water. Mineral deposits or contaminants may also affect performance. This GE replacement is also compatible with Hotpoint, RCA, and some Kenmore models.
Washer won't start or stops mid-cycle? This main control board restores cycle selection and timing. Common DIY fix, takes about 10-20 minutes to install.
Stack kit connector for washers. Secures dryer to washer when stacking units vertically. Replace if cracked, broken, or missing from your kit.
Size: 8-18 b.
Stainless steel hex washer head screw for securing appliance panels, brackets, and trim. Replace missing, stripped, or corroded fasteners during repair.
Plastic housing that secures the drain solenoid to the pump assembly. Replace if cracked, broken, or missing to properly position the solenoid mechanism.
Harness to corset & shifter
Secures washer hoses at pump, tub, and valve connections to prevent leaks and hose blow-offs. Replace worn or missing clamps for a tight seal. Confirm fit.
Fix water leaking from the top of your washer or spraying everywhere. This funnel shower head assembly disperses water evenly. Moderate DIY repair.
Washer only fills with cold water or won't stop dripping? The triple water inlet valve controls hot, cold, and warm water flow. DIY repair in 10-15 minutes.
Connects the pressure switch to the tub in top-load washers. Replace if cracked, punctured, or brittle to restore proper water level monitoring.