Parts for Ge UNC15NJBII: Controls Parts

This reed switch and harness assembly detects door open/closed positions and sends that signal to the appliance control. Replaces a worn or broken door sensor to restore reliable door status detection and related functions. What it does:

• Closes or opens the circuit when the door magnet is nearby so the control knows the door is open or closed
• Commonly replaces a failed door sensor causing interior lights to stay on or controls to ignore door position
• Also used when dispenser or chime functions behave intermittently due to a lost door signal
• Wired harness provides the OEM-style connector for direct swap-in replacement

• Disconnect power before servicing to avoid shock or shorting the control
• Handle the switch and connector gently; avoid bending the reed glass element
• Route the harness the same way as the original and secure any clips to prevent pinching

This replacement interior light bulb restores illumination inside your appliance so you can see contents clearly. Designed as a direct-fit OEM replacement to replace a burned or dim interior lamp. What it does:

• Provides bright interior lighting so food and components are visible
• Replaces a burned-out or flickering interior lamp to restore normal operation
• Fits the appliance's factory light socket for a proper connection and stable contact
• Helps troubleshoot whether an outage is bulb-related before checking wiring or switches

• One interior light bulb

• Disconnect power to the appliance or unplug before replacing the bulb to avoid shock
• Allow the old bulb to cool before removing; use a cloth or gloves to protect from heat and oils
• Remove the cover or diffuser if required, then carefully unscrew the old bulb and install the replacement
• Verify the bulb is rated for the appliance location (cooling compartment vs. cabinet) and seat it firmly but do not over-tighten

This is a main control board assembly for a freezer. This part manages most sensors of the freezer. It controls the run time of the compressor, use of the fans, and other essential functions to ensure the freezer runs at its proper temperature.There are several reasons the main control board assembly would need to be replaced. If the freezer is having trouble cooling properly, or if the freezer is cooling but in an erratic way, the control board may need to be replaced. The control board may also need to be replaced if the freezer does not cool at all. When replacing the main control board, first ensure the freezer is unplugged from the wall. A nut driver set, slot screwdriver and work gloves will be needed to assist in replacing this part.This specific control board is designed for General Electric freezers. It is an authentic OEM replacement part that is directly sourced from the manufacturer. It is sold as a single unit.