Crosley Dishwasher Control Board

The Dishwasher Control Board is an OEM part for Frigidaire dishwashers. It operates as the central "brain" of the dishwasher, controlling functions like cycle selections, wash and rinse levels, heating elements, and input/output sensors.

Causes can be circuitry failures, moisture damage over time, or physical stresses from vibration.

Symptoms of a bad control board include:

• Cycle failure or inability to start or complete washing
• Temperature or input/output sensor malfunctions
• Fault codes appearing or strange appliance behavior
• Unresponsive buttons or input failures

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

This switch assembly is used in select dishwashers to provide a precise open/closed electrical signal to the control. Replacing a worn or sticking switch helps restore consistent cycle operation and reliable responses from the affected function. What it does:

• Sends an on/off (open/closed) signal to the control for the related mechanism in your model
• Helps ensure the connected function engages only at the correct time
• Common symptoms of a failed switch can include: cycle won't start, intermittent stopping, or improper filling/draining behavior
• A sticking or heat-damaged switch may cause erratic operation or error alerts

• One switch assembly

• Disconnect power (and water supply if required by access) before servicing
• Access location is model-specific; photograph wiring and note terminal positions before removal
• Transfer or reuse existing mounting hardware as applicable; ensure firm terminal connections
• After install, check switch actuation and run a test cycle to normal operation