How to Troubleshoot & Replace Whirlpool AP6012289 / WP8269145 Dishwasher Undercounter Mounting Bracket

I noticed that there was water leaking out the front of the dishwasher door. The original hard plastic door seal was warped and had a piece broken off. This is not the rubber door seal along the side, but the hard plastic lower door seal. First, unplug the dishwasher or turn off the circuit breaker. I removed the screws from the inside of the door so that I could remove the front cover. Then, I also removed the hinges from the door. That gave me easy access to the tiny screws holding the plastic seal on. I notice other people have left the door on, but I found it easier to access the door seal screws this way. You will need to unplug the top control panel to remove the door. Replaced the piece and put everything back together. Also leveled the dishwasher a bit better. Works great. Pretty easy project over all. 30 minutes. 

I pulled the dishwasher out from under the counter about 3 inches. Replacing the broken bracket was simple because I watched your video. I was also able to correct the installation of the other bracket (there are two on top of the dishwasher) because it had been installed incorrectly. The entire job took less than 15 minutes. The only part of the job that took a little effort was snipping off the end of the bracket to fit properly. 

Had to order reploacement brackets from Appliance Parts Pros. The parts were an exact replacement for the OEM Maytag mounting brackets. They shipped & arrived very quickly (a couple of days), and the parts took care of the problem. i would use this parts vendor again. 

After several attempts at Local Hardware stores and Lowe's and Home Depot to find them I called AppiancePartsPros.com. I gave them the model number and what I was looking for and customer service directed me to the part on the Web site. They were extremely helpful and it was very fast and I got the parts the next day. 

One of the two counterweight springs designed to lighten the weight of the door had lost its connection. I watched your repair video, ordered the parts and it's like new! Thank you!! 

We ordered the part from AppliancePartsProcom. It came in a couple of days. The part was the correct one and my dishwasher is back to 100%. We are very pleased with the delivery time and the easy of ordering on their website. 

Changed the Spray arm seal, Changed the Sprayarm bearing and the 3rd level wash spray. It is as good as new now (for about $20.00). Watched the videos and became an "expert". really easy. I also removed the lower screws and removed all debris (food residue) from the inlet of the pump. this improved the water flow. (no parts needed, just a star screw driver) very easy. 

I bought a floor model dishwasher because my dishwasher was beyond repair and I needed a dishwasher now. Anyway because it was a floor model I got a deep discount but it did not come with a kick plate. I ordered an Access Panel, retainer, and an undercounter Bracket. The Access panel fit fine after a little adjusting of the mounts on the dishwasher, but the Retainer came in a pack of one so I hit the auto parts store and got some trim clips and that did the trick. The undercounter bracket was an easy install, the dishwasher only came with one so I only needed one and it also came in a one pack. My only complaint is that the overpriced retainer should say that it is a one pack. 

I ordered 2 stops (just in case the other one breaks) and was able to easily pop out the old and pop in the new. No need to buy announce trail or some big assembly. Delivered the next day! 

We purchased this part from applianceparts.Pro & the parts were here in a matter of days. great service, even had a video on they're website on how to install the parts. very good service & didn't take long to install at all.