Do-It-Yourself Story

I ordered the parts suggested with 2 exceptions. I needed a hub nut wrench and I should have ordered a fuse link that had blown. The washer was loud and would not spin so I ordered the shaft and mode shifter assembly. I also replaced the seal, bushings and all washers. The Hub Nut is extremely hard to get off and after rounding the nut off and much wd40 I resorted to a short pipe wrench. After beating the finger up and a lot of banging with a hammer it came loose. The nut and split ring was both bad and disintegrating. I got it all back together and the fuse link had blown. Not much on the location of that or how to test it. But found it in the right front wiring harness, then had to strip wire down to test and replace and bingo the washer runs like new now...