Parts for Bosch B36IT71NNP/11: Door Assembly Parts

This is an active carbon filter designed to remove odors from inside the refrigerator compartment. It absorbs and neutralizes food smells to keep the interior air fresh. Replace this filter if you notice persistent unpleasant odors inside the refrigerator despite cleaning, or on a regular maintenance schedule as recommended.

Removes impurities from your refrigerator's water and ice supply. Replace every 6 months for clean, fresh-tasting water. Verify fit by model number.

Mounting bracket fixture secures internal components inside your refrigerator. Replace if broken, cracked, or worn to restore proper alignment and fit.

Replace a cracked, broken, or missing cover panel on your refrigerator. This structural component installs to conceal internal parts and mechanisms.

Protective housing cover shields internal refrigerator components from debris and moisture. Replace if cracked, broken, or missing to maintain safe operation.

Secures internal components to reduce vibration and noise in your refrigerator. Replace if broken or loose to restore stability. Verify fit with your model.

The Mullion Heater is an OEM part for Bosch refrigerators. It is designed to prevent condensation from forming on the refrigerator door mullion, the vertical divider between the doors. This heater ensures that the mullion stays warm enough to stop moisture from condensing and causing potential water damage or mold growth.

Causes of a bad mullion heater can include electrical failures, wear and tear from continuous use, or manufacturing defects.  

Symptoms of a bad mullion heater include:

• Visible condensation or frost on the door mullion
• Water pooling or dripping around the door area
• Increased humidity inside the refrigerator
• Mold or mildew developing near the door seal

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

Mounting hardware kit secures refrigerator components in place. Replaces worn, missing, or damaged fasteners that cause rattling or loose parts inside unit.

This perimeter door gasket creates an airtight seal around the refrigerator or freezer door to maintain proper internal temperatures. It fits into a channel along the edge of the door and uses a magnetic strip to hold the door securely closed. Replace it if the door doesn't seal tightly, you notice condensation or frost forming inside the unit, or the gasket is visibly warped, torn, or hardened.

Replacement tray for refrigerator interior organization. Installs in fresh food or crisper section. Needed when original is cracked or broken.

Replace a cracked or broken light fixture in your bottom-mount refrigerator. This housing mounts inside the cabinet to secure and protect the bulb.

Factory repair set restores proper refrigerator operation by replacing worn service components. Verify fit with your model number before ordering.

Freezer compartment door for bottom-mount refrigerators. Replaces cracked, broken, or damaged doors that no longer seal properly or are structurally compromised.

Replacement shelf rail for refrigerator shelves. Installs along the interior wall to support sliding or adjustable shelves. Needed when original is cracked, broken, or missing.

This front door panel replaces a damaged or dented dishwasher door to restore appearance and proper closure. It provides the outer surface and mounting points needed for normal operation and a finished look. What it does:

• Replaces a cracked, dented or cosmetically damaged front door panel
• Restores proper sealing and alignment so the door closes evenly
• Provides original mounting points for the handle, console and hinges
• Helps prevent water intrusion and protects internal components

• Disconnect power and water supply before beginning any repair
• Support the door assembly while removing hinge fasteners to avoid dropping
• Handle panel edges carefully to avoid cuts or damage to the finish
• Reuse original screws, handles and trim unless replacement parts are specified

Refrigerator door seal creates an airtight barrier to maintain internal temperature. Replace if cold air escapes or condensation forms. Confirm fit with model.

Removes impurities from your refrigerator's water and ice supply. Replace every 6 months for clean, fresh-tasting water. Verify fit by model number.