Parts for Alliance CTSA7AWN: Drain Hose / Pump Parts

This replacement porcelain touch-up paint restores small chips, scratches and worn spots on enamel-coated appliance surfaces to help improve appearance and slow surface corrosion. Easy to apply for spot repairs. What it does:

• Covers small chips, scratches and scuffs on porcelain/enamel surfaces
• Helps protect exposed metal from moisture that can lead to surface rust
• Matches factory finish color on compatible porcelain-coated panels (spot repairs only)
• Useful for finishing edges around dings and improving visual appearance

• One bottle of porcelain touch-up paint

• Clean and dry the repair area thoroughly; remove loose paint and rust before applying
• Test paint in an inconspicuous spot to confirm color match and adhesion
• Apply sparingly with a fine brush or applicator; allow recommended drying time between coats
• Keep away from open flame; store and dispose of per local regulations; keep out of reach of children

This washer drain pump removes water from the tub during the drain and spin portions of the cycle. Replacing a failing pump restores proper draining and helps prevent standing water, error codes, and extended cycle times.

• Pumps wastewater out through the drain hose so the washer can complete drain and spin cycles
• Failure symptoms include water left in the tub, slow/no draining, or drain-related error messages
• Also presents as loud humming/grinding from the pump area or leaks around the pump/hose connections
• Restores consistent water removal to help the washer reach and maintain proper spin speeds

• Disconnect power and water supply; bail or drain remaining water and protect the floor
• Access the pump, note hose orientation, and disconnect hoses; if present, unplug the wire harness; remove mounting fasteners
• Transfer any brackets or clamps from the old pump as needed and ensure all hose connections are tight and properly oriented
• After installation, run a drain/spin to check for leaks and proper water removal

This pump housing is the molded case that holds the washer's drain pump and channels wastewater out of the tub. Replacing a cracked or damaged housing restores proper drainage and helps stop leaks. What it does:

• Houses and secures the drain pump assembly
• Directs discharged water from the pump to the drain line
• Helps maintain pump alignment and prevents leaks from the pump area
• Common symptoms indicating replacement: leaking near the pump, poor or slow draining, and unusual pump noise

• Disconnect power and shut off water supply before starting any repair
• Drain the washer tub and remove surrounding panels to access the pump housing
• Inspect pump, seals, gaskets, and mounting hardware; replace any worn components
• Tighten fasteners snugly but avoid overtightening; test for leaks after reassembly