Parts for Whirlpool WET4027EW0: 06 - Dryer Support And Washer Harness Parts

This wire harness connects the dryer's control and components to deliver power and signals, restoring reliable electrical connections. It's a direct-fit replacement when the original wiring is damaged or terminals are corroded. What it does:

• Routes and links power and control signals between the console, motor, heater, and other dryer components
• Replaces cracked, frayed, burned or loose wires and terminals that cause intermittent operation
• Resolves symptoms like no heat, no start, intermittent cycles, or components that don't respond
• Ensures proper connector fit and correct wire routing when installed as directed

• One replacement wire harness as shown

• Disconnect power (unplug or turn off breaker) before beginning any repairs
• Take reference photos of wire routing and connector positions before removal to ensure correct reassembly
• Match all connector shapes and pin positions; route and secure harness away from moving or hot parts
• If you detect melted insulation or a short, inspect surrounding components and replace any damaged parts before re-energizing

Specs: 10-16 x 1/2 inch.

The Whirlpool screw is an OEM replacement part responsible for securing various components or parts on different types of Whirlpool appliances. The screw is designed to provide a secure and reliable fastening connection, ensuring that different parts of the appliance stay in place. It is commonly used in different locations within the appliance, such as the cabinet, panels, or other structural elements.

This part fixes the following symptoms:

• Loose or wobbly components within the appliance
• Panels or parts that are not securely attached
• Rattling or unusual noises due to loose parts
• Damaged or missing screw

The Whirlpool screw can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

This cover screw secures appliance panels and covers, keeping components protected and aligned. Replace missing, stripped, or corroded screws to restore a tight fit and help eliminate rattles, gaps, or panels that won't stay in place.

• Attaches an access cover or panel to the appliance frame
• Helps maintain proper alignment to protect internal components
• Replaces missing, stripped, or rusted hardware
• Typical signs: loose or rattling panel, cover won't stay secure, damaged or rounded screw head

• Disconnect power before servicing
• Support the panel while removing and installing screws to prevent misalignment
• Start threads by hand to avoid cross-threading; do not overtighten
• Use a matching driver bit to avoid damaging the screw head