Parts for Electrolux E24ID74QPS0A: 04 - Electrical Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Fix I10, I20, or I30 error codes and slow water filling with this dishwasher water inlet valve. Stops mid-cycle failures and prevents leaks. DIY install.

Fix standing water in your dishwasher with this drain pump assembly. Resolves drainage issues and prevents water backup. Direct replacement part.

Fix a dishwasher that won't drain or fill properly with a new water pump. This part circulates water during wash cycles. Moderate difficulty repair.

Fix i20 or i30 error codes with this dishwasher pressure sensor. Monitors water pressure to prevent overfilling. Common DIY repair for continuous filling.

Replacement sensor assembly that detects appliance operating conditions and sends readings to the control system for proper operation. Installing a working sensor restores reliable feedback and helps resolve related error codes or inconsistent performance. What it does:

• Detects operating conditions and provides electrical feedback to the appliance control.
• Enables the control board to monitor and adjust cycles based on measured readings.
• Faulty or intermittent sensors can cause incorrect readings, error codes, or unstable/incorrect appliance operation.
• Replacing a failed sensor restores accurate sensing and helps return the appliance to normal function.

• Always disconnect power to the appliance before starting work to avoid shock or injury.
• Handle the sensor and wiring gently; avoid pulling on wires or bending sensor probes sharply.
• Ensure connectors are fully seated and routed clear of moving parts or heat sources.
• After installation, restore power and verify proper operation and that any previous error codes are cleared.

If your dishwasher won't start or stops mid-cycle, a faulty door lock may be the cause. This safety component secures the door during wash cycles.

This switch assembly restores electrical on/off control for a specific appliance function. Replace a worn or failed switch to stop intermittent operation and return reliable control to the affected circuit. What it does:

• Provides the electrical on/off or function control for the appliance circuit.
• Replaces a failed switch that can cause intermittent operation or unresponsive controls.
• Helps resolve symptoms such as a function that won't start, no response from the control, or erratic switching.
• Connects to the existing wiring harness and mates with the original mounting points.

• Disconnect power to the appliance before beginning any work.
• Remove the appropriate access panel to reach the switch; note wire and terminal locations before disconnecting.
• Unplug the wiring harness or carefully detach terminals, swap the switch assembly, then reconnect securely.
• Restore power and verify the replaced switch operates the function correctly.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Fix dishwasher that won't start, stops mid-cycle, or has unresponsive buttons. This control assembly manages wash cycles and user interface functions.

Illuminates your dishwasher interior for better visibility when loading and unloading dishes. Replace if light fails or dims due to wear or damage.

Replacement mounting screw for dishwashers. Secures interior components and panels. Order a new screw if yours is stripped, missing, or damaged.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.