Parts for Electrolux EI24ID30QB0A: 04 - Electrical Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Fix I10, I20, or I30 error codes and slow water filling with this dishwasher water inlet valve. Stops mid-cycle failures and prevents leaks. DIY install.

Fix a dishwasher that won't drain or hums during drain cycle. This drain pump assembly removes standing water and completes wash cycles. Moderate DIY repair.

Fix a dishwasher that won't start or hums but doesn't run with this capacitor. Common fix for motor startup issues. Simple DIY repair in 30 minutes.

Fix i20 or i30 error codes with this dishwasher pressure sensor. Monitors water pressure to prevent overfilling. Common DIY repair for continuous filling.

Fix a soap door that won't open or stay closed. This detergent dispenser releases soap at the right time during wash cycles. DIY-friendly repair.

If your dishwasher won't start or stops mid-cycle, a faulty door lock may be the cause. This safety component secures the door during wash cycles.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This switch assembly restores electrical on/off control for a specific appliance function. Replace a worn or failed switch to stop intermittent operation and return reliable control to the affected circuit. What it does:

• Provides the electrical on/off or function control for the appliance circuit.
• Replaces a failed switch that can cause intermittent operation or unresponsive controls.
• Helps resolve symptoms such as a function that won't start, no response from the control, or erratic switching.
• Connects to the existing wiring harness and mates with the original mounting points.

• Disconnect power to the appliance before beginning any work.
• Remove the appropriate access panel to reach the switch; note wire and terminal locations before disconnecting.
• Unplug the wiring harness or carefully detach terminals, swap the switch assembly, then reconnect securely.
• Restore power and verify the replaced switch operates the function correctly.

This replacement cover protects internal housing and components, restoring the appliance's finished appearance and helping keep dust, moisture and debris away from controls. It's a simple, direct part for cosmetic and protective repair. What it does:

• Shields control electronics and internal components from dust and accidental contact
• Restores the appliance's exterior look after damage or wear
• Helps prevent debris buildup that can affect component function
• Supports secure mounting of adjacent panels or trim

• Disconnect power (unplug or turn off breaker) before servicing
• Remove any trim or screws that secure the old cover; keep fasteners if they are reused
• Handle plastic edges gently to avoid cracking; align tabs before tightening screws

Replacement mounting screw for dishwashers. Secures interior components and panels. Order a new screw if yours is stripped, missing, or damaged.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.