Electrolux Range Bracket & Flange

This support bracket secures and stabilizes appliance components, restoring proper alignment and stopping movement. It's a simple replacement that helps reduce rattling and prevents panels or assemblies from shifting during use. What it does:

• Provides a rigid mounting point to hold panels, trim, or internal assemblies in place
• Restores proper alignment when a worn or broken bracket causes gaps or looseness
• Reduces vibration and rattling caused by a damaged or missing support
• Keeps connected parts from shifting, which can prevent further wear or damage

• Disconnect power to the appliance before beginning any repair
• Verify the bracket orientation and fit against the mating surface before fastening
• Use the factory screw locations and hardware; tighten screws securely but avoid over-torquing

This mounting bracket secures internal panels or components to the appliance frame, restoring stable support and alignment for proper operation. Use when a bracket is bent, broken or missing to reduce rattling and keep parts positioned correctly. What it does:

• Anchors panels or components to the cabinet/frame to prevent movement and vibration
• Restores proper alignment of doors, panels or internal assemblies
• Stops rattling or buzzing caused by loose or damaged support hardware
• Helps maintain safe clearance between parts and wiring or moving components

• Disconnect power to the appliance before starting any repair
• Basic hand tools typically required; follow OEM instructions for correct fastener locations
• Inspect adjacent fasteners and mounting surfaces; replace any damaged screws or clips
• If bracket is corroded or severely deformed, replace rather than re-bend to ensure proper fit

This mounting bracket provides a secure support point for the appliance assembly where it attaches to the cabinet or adjacent components, helping maintain proper alignment and stable operation. What it does

• Secures panels or components to the appliance frame to prevent movement or sagging
• Keeps aligned parts properly positioned to reduce noise and wear
• Helps restore fit and finish after repair or component replacement
• Common symptom: loose, misaligned, or rattling panels near the mounting location

• Installation requires basic hand tools; disconnect power before servicing appliances with electrical components
• Retain original fasteners when possible; replace any stripped or damaged screws
• Inspect mating surfaces for damage or corrosion and clean before installing the bracket

This mounting bracket secures appliance panels or internal components to help keep parts aligned and stable during normal use. It replaces a worn or broken bracket to reduce movement and restore proper fit between parts. What it does:

• Provides a secure attachment point for panels, trim, or internal components
• Helps stop rattling, vibration, or shifting caused by a loose or damaged bracket
• Maintains correct alignment so doors, drawers or panels close and fit properly
• Supports structural stability where an OEM bracket has failed

• Disconnect power and empty the area before starting any repair
• Use original screws or fasteners; replace damaged hardware as needed
• Hand-tighten and then snug fasteners—avoid over-tightening which can crack plastic parts