Electrolux Wall Oven Trim

This replacement frame restores the appliance's front cabinet trim for a finished look and secure component fit. It helps protect internal parts and keeps the control area or door edges properly aligned. What it does:

• Replaces damaged, cracked, or warped front trim that affects appearance or fit
• Secures adjacent panels and provides a mounting surface for controls or seals
• Helps stop drafts or gaps that can form around doors or control openings
• Restores proper alignment to reduce rubbing or interference with moving parts

• One replacement frame as pictured

• Disconnect power (unplug or switch off breaker) before starting any repair
• Basic hand tools (screwdriver, nut driver) are typically required; keep fasteners for reuse if intact
• Handle edges carefully to avoid scratching the finish; protect surrounding surfaces during installation

This decorative trim bezel restores a clean finished look to the appliance's opening or control area and covers gaps or fasteners for a factory appearance. It's a direct-fit cosmetic replacement that helps maintain the original styling. What it does

• Covers and protects the edge of the opening or control panel for a finished appearance
• Hides mounting hardware and seals small gaps between panels
• Helps reduce dirt and grime buildup along the appliance opening edges
• Common symptom: cracked, scratched, missing, or warped trim that affects appearance

• Disconnect power to the appliance before starting work to avoid shock or injury
• Trim typically secures with clips or screws; keep and reuse original fasteners when possible
• Handle edges carefully—trim pieces may have sharp metal or plastic edges
• Check adjacent panels and mounting points for damage before forcing the trim into place

This decorative outer trim restores the finished appearance of the appliance and helps protect edges around the door or control panel. It replaces damaged, chipped, or missing trim to keep the appliance looking like new. What it does

• Provides a finished, clean edge around the appliance door or control area
• Hides gaps and covers mounting edges for a factory look
• Replaces cracked, dented, or worn trim that affects appearance
• Keeps adjacent components protected from dings and scrapes

• One decorative outer trim piece as shown

• Disconnect power (and gas supply, if applicable) before beginning work
• Remove any door or panel to access trim mounting screws or clips
• Handle with care to avoid scratching or chipping the new trim; use appropriate hand tools
• Keep all fasteners and alignment tabs; verify fit before tightening completely