Parts for Kitchenaid KSSC48MFS05: 11 - Freezer Door Parts

The Screw is an OEM part for Whirlpool refrigerators. This screw plays a small but important structural role, securely fastening the refrigerator door hinges in place.

Causes of a bad screw include normal wear and tear, repeated door opening/closing stress, or accidental damage during cleaning or servicing of the hinge area.

Symptoms of a bad hinge screw include:

• Loose or sagging door that does not close or seal properly
• Increased vibration or noise from the hinge area
• Difficulty opening/closing the door smoothly

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This flexible perimeter seal fits around the refrigerator door to keep cold air in and humid air out. Replacing a worn gasket restores a tight closure, stabilizes temperatures, and helps reduce frost, condensation, and energy waste. What it does:

• Seals the gap between the door and cabinet to prevent air leaks
• Helps maintain proper internal temperature and humidity
• Reduces frost and condensation caused by warm-air infiltration
• Corrects: visible gaps, torn/cracked gasket, door not sealing or popping open, excess moisture or frost

• 1 refrigerator door gasket

• Unplug the refrigerator before starting
• Lay the new gasket flat and warm it (warm water or low heat) to relax folds
• Remove the old gasket and clean the sealing surface/channel thoroughly
• Install starting at the corners, ensure the gasket is fully seated and evenly contacting the cabinet; adjust door alignment if needed

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

Size: 10-24 x 3/8 inch.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This top door spacer positions and supports the upper edge of the appliance door to maintain correct clearance and alignment for smooth opening and closing. It helps keep the door trim and glass properly spaced for reliable operation. What it does:

• Keeps the top edge of the door correctly spaced from the cabinet to prevent rubbing or binding
• Helps maintain door alignment for an even seal and consistent closing
• Reduces vibration-related noise by stabilizing the door assembly
• Protects trim and glass from contact damage at the top edge
• Useful when replacing worn or missing door support components

• One top door spacer

• Disconnect power to the appliance before starting any repair
• Remove the door or door trim panels per the manufacturer's instructions to access the spacer
• Handle door glass and trim carefully; use appropriate tools and support to avoid damage