Parts for Ge GSS25ETHCBB: Fresh Food Section Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

The Light Lens Shield is an OEM component for GE refrigerators. As a cover installed behind the door light source, it protects sensitive refrigerator components. This shield measures about 16 inches wide by 5 inches high.

Normal wear occurs due to regular door opening/closing cycles inevitably generating friction over many years. Excessive impact from heavy load placements could potentially crack rigid plastic covers as well.

Symptoms of a damaged or defective light lens shield include: 

• Gaps exposing electrical wiring to potential spills
• Loose fit unable to block light leakage from peeping behind
• Signs of stress fractures or cracks in the protective covering
• Discolored stains or residue buildup along plastic edges

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This cam mechanism helps the refrigerator door close properly by providing the correct closing force and alignment for the lower hinge. It ensures the door seals tightly and maintains proper spacing from the cabinet. Replace this part if your refrigerator door doesn't close completely, hangs crooked, or requires excessive force to shut.

Bottom adjustable hinge pin for refrigerator doors. Installs at the lower hinge to level and align doors. Replace if worn, stripped, or doors won't stay level.

Refrigerator not cooling but freezer works? This air damper and thermistor assembly controls airflow between compartments. Restores proper cooling.

Refrigerator too cold or freezing food? The damper cover assembly controls airflow between compartments. Common DIY repair restores proper temperature.

Closes and protects the end of your refrigerator's mullion air duct on the door jamb. Replace this cap if cracked, broken, or missing to maintain a finished appearance.

Mullion air duct for side-by-side refrigerators. Directs cold air between freezer and fresh food sections. Replace if cracked, broken, or damaged.

Air return grille for refrigerators. Covers the air duct opening in the interior. Replace if cracked, broken, or missing to restore proper appearance.

The Light Bulb (40W) is an OEM component for GE refrigerators. As an essential task lamp, it illuminates the interior of the refrigerator and freezer compartments. 

All light bulbs will eventually burn out with consistent use over many years. Vibration during compressor cycles can also potentially disrupt bulb filaments faster. 

Symptoms of a burnt out refrigerator light bulb include:

• Dim or no light illuminating inside refrigerator shelves  
• Shadows and dark spots making it difficult to find items
• Higher utility costs from leaving the door open to see inside

This bulb is also compatible with refrigerators from brands like Hotpoint, RCA, and some Kenmore models. 

Seals the air damper opening between freezer and fresh food compartments to prevent air leaks and maintain stable temperatures. Replace if worn or cracked.

Black

Protective cover for the fresh food compartment temperature sensor in your refrigerator. Replace if cracked, broken, or missing to shield the thermistor.

12-24 TT HX .811

12-24 CA HX 7/8 S

Secures the hinge cover to your refrigerator door or cabinet hinge. Replace this screw if it's missing, stripped, or damaged to stop the cover from loosening.

Replacement 8-18 x 3/4 inch pan/hex head screw for securing refrigerator panels, trim pieces, and brackets. Restores proper fastening for loose parts.

A direct-replacement hi side air separator that helps remove trapped air from the appliance high-side fluid line to restore steady flow and reliable performance. Replaces a worn or clogged separator to address flow interruptions and noise. What it does:

• Separates trapped air from the high-side fluid line so the system can maintain proper flow
• Helps reduce symptoms like intermittent flow, sputtering or aerated output, and unusual operational noise
• Restores consistent performance when a damaged or blocked separator is the cause
• Works as a direct-fit replacement when the OEM separator has failed

• One hi side air separator

• Disconnect power to the appliance before starting any work
• Shut off water or service valves as applicable and relieve system pressure per manufacturer instructions
• Inspect surrounding fittings and seals; replace any damaged components to prevent leaks

This replacement water filter cover restores the protective housing that secures and seals the refrigerator's inline water filter, helping maintain proper filter alignment and reduce the risk of leaks or contamination at the filter location. What it does

• Replaces a cracked, warped or missing water filter cover that no longer holds the filter in place.
• Secures and shields the water filter housing to help prevent leaks and keep out dirt or debris.
• Restores correct filter seating so water flow and dispensing operate as intended.
• Useful when the cover no longer snaps closed or shows visible damage.

• One water filter cover (housing) as shown.

• Turn off the water supply and remove pressure from the line before replacing the cover.
• Unplug the appliance or switch off power at the cabinet to avoid electrical hazard when accessing the filter area.
• Remove the old cover by releasing retaining tabs, then snap the replacement into place until fully seated.
• Check for leaks and proper filter engagement before returning the appliance to normal use.

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

Bypass cap allows refrigerator water and ice dispensers to work without a filter installed. Replace if cracked or leaking. Confirm fit with your model.

Replace your refrigerator's water filter manifold when you notice low water pressure or leaks. Ensures clean, filtered water flow. Confirm fit with model.

Replacement cold water reservoir tank for refrigerators. Installs behind the crisper drawer. Replace if cracked, leaking, or causing contamination issues.

Wire tie retainer for refrigerators. Secures and organizes internal wiring. Replace if cracked, broken, or missing to keep wires properly bundled.