Frigidaire Microwave Guard, Shield, Barrier Parts

The Wave Guide Cover is an OEM part for Frigidaire microwaves. The cover prevents food particles and moisture from entering the wave guide, helping to maintain the efficiency and safety of the microwave.

Causes of a bad wave guide cover can include exposure to high heat, splatters from food and liquids, or regular wear and tear. 

Symptoms of a bad wave guide cover include:

• Sparks or arcing inside the microwave
• Uneven cooking or heating
• Visible burns, cracks, or discoloration on the cover
• Noise or rattling sounds during operation

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This replacement cover restores a clean, secure fit over an opening on your appliance, helping shield internal components from dust, moisture, and debris. Replace a damaged or missing cover to maintain proper protection and appearance. What it does:

• Shields internal parts from grease, dust, and debris intrusion
• Helps maintain proper airflow and component protection as designed
• Reduces vibration or rattling from loose or broken panels
• Restores a finished, factory look when the original is cracked or missing

• 1 cover

• Disconnect power to the appliance before servicing
• Note fastener locations and orientation for correct reinstallation
• Reuse original screws/clips unless your unit specifies otherwise
• Use gloves and caution—panel edges and surrounding metal can be sharp

This replacement cover is a protective panel used in the microwave assembly. It shields internal components from grease and debris and restores a clean, secure barrier when the original cover is cracked, burned, or missing.

• Shields internal components from food splatter, steam, and grease
• Helps maintain proper airflow and safe operation inside the cavity
• Common signs it's needed: cover is warped, cracked, scorched, loose, or missing
• Reduces arcing/sparking or buzzing caused by a damaged or contaminated cover

• Disconnect power before servicing; allow hot surfaces to cool
• Remove screws or release tabs to take off the damaged cover; reuse existing hardware if applicable
• Clean surrounding area to remove grease or debris, then seat the new cover fully and secure without overtightening
• For microwaves, internal high voltage can remain even when unplugged.

This LED light sheet is the refrigerator interior light assembly that provides even, long-lasting illumination so you can see inside the fresh food and freezer compartments. It replaces a failed or dim/fractured LED panel. What it does:

• Replaces the refrigerator's interior LED panel to restore consistent lighting
• Resolves symptoms such as no light, dim or flickering illumination, or visible damage to the light panel
• Provides a direct-fit LED sheet that mounts behind the interior lens or reflector
• Works with the refrigerator's existing wiring and connector

• Disconnect power to the appliance before beginning work to avoid shock
• Handle the LED sheet by the edges; avoid touching LEDs and circuit traces
• Use basic hand tools to remove the interior light cover and mounting screws; keep track of fasteners

This replacement wrapper is the molded housing panel that secures and protects internal components, helping keep wiring and assemblies in place for reliable operation. It restores proper fit and prevents rubbing or exposure of parts. What it does

• Secures and shields internal assemblies to prevent contact and wear
• Keeps wiring and components positioned to reduce vibration and noise
• Restores proper alignment where a cracked or missing wrapper caused loose parts
• Helps maintain safe clearance between moving parts and electrical components

• Unplug the appliance or disconnect power before beginning work.
• Access may require removing outer panels or trim; keep track of screws and fasteners.
• Inspect surrounding clips, brackets and fasteners; replace if damaged to ensure secure fit.