Frigidaire Microwave Parts

This lower front grille covers the appliance's lower cavity and provides a finished look while allowing airflow where needed. It replaces damaged, bent, or missing lower kickplate trim to restore appearance and proper venting. What it does:

• Covers and protects the appliance's lower access area and components behind the kickplate
• Maintains intended airflow/vent clearance in the lower front area
• Restores the appliance's finished exterior when the original grille is dented, cracked, or missing
• Reduces rattles or vibration caused by a loose or damaged panel

• One lower front grille

• Disconnect power to the appliance before removing or installing panels
• Installation typically requires removing the lower drawer or access screws; retain fasteners for reuse
• Handle edges carefully to avoid scratches; plastic clips or tabs can be fragile on older units

This is the outer door panel for a microwave, finished in white. It forms the exterior-facing surface of the microwave door and houses the handle area and control panel trim. Replace this panel if it is cracked, discolored, damaged, or if the door no longer closes securely due to a warped or broken outer panel.

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary

Fix a microwave that won't start or has no display with this control power transformer. Supplies low-voltage power to control board and electronics.

Guides and tensions the turntable drive belt in microwaves. Replace if worn, cracked, or causing friction. Restores smooth turntable rotation.

Fix a microwave that won't start or stops mid-cycle with this monitor switch. Common safety component failure. Moderate DIY repair with basic tools.

Plastic push mount rivet that secures the microwave stirrer cover in place. Replace if the original rivet is broken, cracked, or missing.

Fix a microwave door that won't close or latch properly with this door latch pawl. Simple repair part for doors that pop open or won't stay shut.

Black exhaust grille covers the vent opening on microwaves. Replace if cracked, broken, or missing to restore a clean appearance and proper airflow.

Hood and damper assembly for over-the-range microwaves. Mounts at top or rear for external venting. Replace if cracked, broken, or missing.

Installation instructions for microwave filler kit. Guides proper mounting and alignment of trim filler panels. Replace if missing or damaged during install.

Replacement glass panel for microwave door. Installs in door frame assembly. Order if your current glass is cracked, broken, sagging, or missing.

Replacement power cord for microwaves and ovens. Restores mains connection when original cord is damaged, frayed, worn, or missing. Direct plug-in.