Frigidaire Range / Cooktop / Oven Gasket & Seal

Replace your range oven door seal to maintain proper heat retention and cooking efficiency. Prevents heat loss and improves energy use. Verify fit with your model.

This O-ring is a small rubber seal that restores a watertight connection at a plumbing or valve joint, helping stop drips and leaks and keep your appliance operating normally. What it does:

• Provides a flexible, compressible seal between two mating parts to prevent water leaks
• Commonly used on valve fittings, hose connections, and dispenser plumbing
• Symptoms a failing O-ring can cause: visible dripping, pooled water, or intermittent water flow
• Small, low-cost part that often resolves minor leaks when the correct size is used

• Turn off water supply (and power if applicable) before replacing the O-ring
• Remove the old O-ring and inspect mating surfaces for damage or debris; clean before installing the new ring
• Do not reuse a deformed or torn O-ring; install the correct size and seat it evenly
• After installation, restore water and check the connection for leaks; tighten fittings only as needed to avoid crushing the O-ring

Cooktop burner gasket seals burner assembly to prevent gas leaks and maintain proper flame. Replace if cracked, brittle, or damaged. Confirm fit with model.

Seals the outer glass panel on your range oven door to prevent heat loss and improve efficiency. Replace if worn, cracked, or heat escapes. Verify fit.

Door gasket creates an airtight seal for your range oven. Replace if torn, brittle, or heat escapes during cooking. Confirm fit with your model number.

Range door gasket creates an airtight seal for efficient heating. Replace if worn, cracked, or oven loses heat. Verify fit with your model number.

This refrigerator/freezer door gasket creates an airtight seal around the door to help maintain proper temperature and reduce energy use. It replaces a worn or damaged seal to improve cooling and reduce frost buildup. What it does:

• Seals the cabinet to keep cold air in and warm air out
• Helps prevent excess frost and moisture inside the compartment
• Reduces compressor run-time caused by air leaks
• Restores proper door alignment and consistent cooling

• Disconnect power and remove food from affected compartment before starting
• Remove the old gasket and thoroughly clean and dry the gasket channel before installing
• Press the new gasket into the channel evenly, starting at a corner and working around the door
• Check the seal by closing the door; adjust or reseat as needed for a uniform contact

Replace your range oven door gasket to maintain proper heat seal and cooking efficiency. Fits select Frigidaire and other models. Verify compatibility.

Replace your range door gasket rope seal to prevent heat loss and improve oven efficiency. Essential when seal shows wear, cracking, or gaps. Verify fit with your model number before ordering.

Oven door seal tape creates an airtight barrier to prevent heat loss and improve efficiency. Replace if worn, cracked, or heat escapes. Verify fit with your model.

This genuine replacement door seal restores a tight refrigerator fresh-food compartment closure to help maintain even temperatures and reduce frost, moisture, and energy loss. Use when the original gasket is cracked, warped, or no longer seals. What it does:

• Creates an airtight barrier between the door and cabinet to keep cool air in and warm air out
• Helps prevent condensation, frost buildup, and uneven cooling in the fresh-food compartment
• Reduces compressor run time and energy waste caused by a failing seal
• Stops door gaps that can allow food spoilage or excess moisture

• One replacement door seal/gasket for the fresh-food compartment

• Unplug the appliance or switch off power before starting any work
• Clean the mounting surface and remove old adhesive or debris for a proper fit
• Warm and flex the gasket if needed (per OEM guidance) to align and seat it evenly; avoid overstretching
• Inspect and reuse or replace retainers/clips as required; test seal by closing the door and checking for gaps

Seals the bake element opening to maintain heat distribution and prevent debris entry. Replace if worn, cracked, or causing uneven baking. Verify fit.