Frigidaire Wall Oven Screws, Nuts, Washers

Washer for oven fan motor mounting assembly. Replaces cracked, worn, or missing washers that secure the motor. Essential hardware for proper installation.

This is a replacement hex nut used to secure appliance components and fasteners. It restores proper fastening where a lost or damaged nut causes loose panels or hardware and helps stop rattling or movement. What it does

• Secures panels, brackets, or components to threaded studs or bolts
• Restores proper tension where a missing or stripped nut allows parts to wobble
• Helps eliminate noise from loose hardware and prevents further wear
• Used wherever a matching-thread nut is specified by the manufacturer

• Confirm thread size and type match the original before installing
• Hand-thread first to avoid cross-threading, then tighten with appropriate tool
• Wear eye protection and disconnect power to appliance if working near electrical components
• Do not overtighten; replace any damaged studs or bolts rather than forcing this nut

A single replacement mounting screw that secures the transformer to the appliance chassis. Keeps the transformer firmly attached to help maintain reliable power to the controls and reduce vibration-related noise. What it does:

• Secures the control/door transformer to the appliance chassis or bracket.
• Prevents transformer movement that can cause rattling or vibration noise.
• Helps maintain proper electrical connections by keeping the transformer stable.
• A missing or loose screw can lead to intermittent power to controls or unusual sounds.

• Always disconnect power to the appliance before starting work.
• Use the correct screwdriver to avoid stripping the head; tighten snugly but do not overtighten.
• Keep original hardware and screw length and thread match before installing.
• If the transformer or wiring looks damaged, replace or inspect components as needed before reassembly.

This flat washer is a replacement fastener spacer that helps secure and evenly distribute load on screws or bolts in your appliance. Installing the correct washer restores proper fastening and prevents metal-on-metal wear. What it does:

• Provides an even bearing surface under a screw or nut to secure assemblies
• Helps maintain proper alignment of parts and prevents loosening from vibration
• Reduces wear and protects mating surfaces from damage
• Commonly used where a thin, flat spacer is required during reassembly

• One flat washer (quantity: 1)

• Turn off and unplug the appliance before starting any repair
• Replace only the washer(s) that match the original location and orientation
• Hand-start fasteners to avoid cross-threading; tighten to OEM torque if specified
• If the original washer shows damage or corrosion, replace it with this new part

Mounting screw for microwave cutout switch assembly. Secures the switch in place during installation. Order a replacement if lost or stripped.

Split lockwasher secures screws and bolts in your oven. Replace if missing, damaged, or worn to maintain stable panel and component connections.

This 10-16 x 1-1/4 screw secures appliance panels and components, restoring proper fit and preventing loose parts. Use it when fasteners are missing, stripped, or causing rattle and misalignment. What it does:

• Fastens trim, brackets, or interior panels to restore secure attachment
• Stops rattling or vibration caused by loose hardware
• Replaces missing or damaged screws to maintain safe operation
• Matches OEM thread and length for correct fit in specified locations

• Disconnect power and empty appliance as needed before servicing
• Use the correct screwdriver or bit to avoid cam-out or head damage
• Do not overtighten; snug until parts seat to prevent striping or cracking
• Replace all matching screws for consistent fit