Frigidaire Wall Oven Control Board

I first felt along each heating element (bake and broil) hoping to find a rough or blistered place on them. But they were both smooth with no irregular places. (replacing the elements would have been the easiest and cheapest repair. Pulled the back off the range (unplugged, of course) - checked wiring. There were no loose connections or burned wiring. I disconnected the elements and checked them with a ohmmeter (VOM) and both had continuity. Discovered that both elements used the same... Read more

I researched online and found that it was probably one of two things wrong: the heat probe or the control board (clock). Since the probe was less expensive, I ordered that on Appliance PartsPros. It arrived SO quickly, and with the repair video I easily replaced it. BUT... it still got the F10 reading. Sigh. So I found a local appliance repairman (I didn't want to replace a more expensive item if it turned out I was wrong). He was a good one: he listened to my story, said he was sure it was the... Read more

I first checked the power , we had 220 volt at plug, I removed the back of the stove, checked things out , I found that the stove top burners still worked and the oven light worked. I tested and found that we had current to the timer and clock but nothing on the control worked to set the time, or to turn the oven on or to set the oven temp. I ordered this part on June 30th and received the next morning. I disconnected stove from electrical plug. Be Sure to unplug the stove for your... Read more

Replaced the oven controller. This needed the only removal of six hex screws securing the back guard rear shield, two-wire plugs on the control unit, and four Phillips screws. All are easily accessible. The only difficulty came from an apparent model design change that separated the control unit and the overlay - the labels for the control buttons (items 20 and 20a in the backyard parts diagram). Mine is a single unit (the overlay could not be removed without damage) led to the assumption that... Read more

I ordered a new kit and replaced it. It was easy except the video on the website did not include how to get off the front sticker. However, I did find another video to help Read more

I ordered the oven control board, I was told that it would fix my problem. I installed it, which was extremely easy, and it worked. The oven worked flawlessly. Read more

We simply removed the back panel off the stove, removed four screws and unplugged the controller. It was so quick and easy. It took about five minutes to replace. Read more

I googled the error code and symptoms my oven was exhibiting to determine the solution and which parts to order. I needed a new control panel and chose also to replace the overlay that shows on the front of the stove. I could have reused the old one because I turned out to be able to remove it without damaging it. I just kept it in case I damage the new one in the future. The “fast” shipping (not overnight) option had the part delivered the next morning, which was a nice surprise. I felt... Read more

Replaced Oven Control Board. I already had removed the old part when I ordered the replacement. Part showed up in 48 hours. It took me about two minutes to install the new part. Tested to make sure it worked, then another 30 seconds to screw the back panel of the stove on. Read more

Had to replace the whole control dual element. Part came very quickly, and replacement was also a snap. Read more

Turned off the power. Pulled out the stove. Removed back of upper part of stove. Removed old control board. Took photos with phone to make sure I got wires back on correctly. Only 1 wire was difficult to remove and required gentle rocking with pliers. Put the overlay on the new board. Placed all the clips and wires back on the new board. Turned on power to test. Tested ok. Turned power off and resecured the board and back on the stove. Repositioned the stove. Turned power back on. I... Read more

I replaced the Controller. And it did the trick. Read more

On their website, I sent a message to the repair tech to explain what was happening. They diagnosed exactly what the problems was and the part I needed to repair it. Thank you for the help. You saved me money in repairs. Read more

Replaced the control board. Read more

Replaced the control panel. Read more