General Electric Washer Dryer Combo Switch

The Lid Switch is an OEM part for GE washing machines. This part prevents the washer from operating when the lid is open. When the lid is closed, the switch activates, allowing the washing machine to proceed with the wash cycle.

Causes of a bad lid switch can include wear and tear from frequent use, damage due to accidental impacts, or electrical failures such as short circuits or corrosion.

Symptoms of a bad lid switch include:

• The washer not starting or stopping mid-cycle
• The machine not draining or spinning
• Error codes related to the lid being detected as open
• The lid not locking or unlocking properly

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

This selector switch mounts behind the console knob and lets you choose wash settings on your washer. Replacing a worn switch restores reliable selection so the control responds to the setting you intend.

• Allows the user to select a wash option and sends that choice to the timer/control
• Helps when the knob won't click or hold a setting
• Addresses issues where settings don't change or only one option works
• Can resolve dead or intermittent positions on the selector

• Disconnect power before servicing
• Access the control console; remove the knob and the switch's retaining hardware
• Move wire connectors from the old switch to the new one one at a time to maintain correct positions
• Secure the new switch, reinstall the knob, and reassemble the console

This electric pressure switch senses pressure changes and sends a signal to the appliance control, restoring reliable pressure detection and normal operation. Use it when the machine fails to detect pressure or shows pressure-related errors. What it does:

• Detects changes in air/water pressure and converts them to an electrical signal for the control board
• Helps the appliance recognize correct fill, drain, or airflow conditions
• Commonly linked to symptoms such as failure to start, not filling, running continuously, or pressure-related error codes
• Replaces a failed or intermittent pressure-sensing component to restore expected cycling behavior

• Disconnect power before attempting any service to avoid shock or damage
• Label and photograph wiring before removal to ensure correct reconnection
• Test with a multimeter if troubleshooting

This selector switch is the console control that lets you choose washer options. It routes power to the appropriate circuit so the setting you pick—such as temperature or speed—engages reliably during the cycle.

• Interfaces with the control knob to communicate user-selected options to the washer's control
• Common fix when options won't change or only one setting works
• Helps resolve intermittent response or dead spots when turning the selector
• Restores consistent operation of user-selected wash features

• Disconnect power to the appliance before servicing
• Access the control console; remove the rear cover or screws as required
• Note wire positions and transfer connectors to the new switch one at a time
• Secure the switch, reinstall the knob/panel, and test each selection

The Flame Sensor is an OEM part for GE dryers. This part detects the presence of a flame in gas dryers, ensuring that the gas ignites properly for safe and efficient drying.

Causes of a bad flame sensor can include regular wear and tear, carbon buildup from the gas flame, or electrical malfunctions.

Symptoms of a bad flame sensor include:

• The dryer not heating or taking longer to dry clothes
• The dryer shutting off unexpectedly during a cycle
• The igniter glowing but not igniting the gas
• Error codes related to heating or ignition issues

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.