General Electric Room Air Conditioner Grille

This louver is a molded air vent piece that restores proper airflow routing and a finished appearance to the appliance. It replaces a cracked, broken, or missing vent louver to help protect internal components and maintain cabinetry aesthetics. What it does:

• Directs and channels internal airflow for even circulation
• Covers a cabinet or grille opening to protect internal parts from debris
• Replaces cracked, warped, or missing louvers that can rattle or look damaged
• Helps restore proper fit and finish on the appliance exterior

• One replacement louver

• Disconnect power to the appliance before beginning any work
• Inspect mounting tabs and clips; replace only if the OEM clips are present or available
• Usually secures with snap-in tabs or a few screws—use appropriate hand tools and avoid over-tightening

This Air Guide Frame helps direct airflow inside the appliance so exhaust and cooling air follow the correct path, protecting internal components and helping the unit vent properly. It's a direct-replacement exterior frame piece. What it does:

• Guides and channels air through the appliance's venting area to maintain proper airflow.
• Holds surrounding trim and ducting in position for a secure fit.
• A damaged or warped frame can cause restricted airflow, rattling, or misaligned trim.
• Restores proper airflow routing when replacing cracked, broken, or bent frames.

• One air guide frame

• Disconnect power (and gas, if applicable) before starting any repair.
• Remove surrounding trim or panels as required to access the frame; keep fasteners for reassembly.
• Inspect adjacent ducts, seals, and mounting tabs for damage and replace if needed.

This replacement guide blade aligns and supports the blade assembly to restore smooth operation and consistent performance. Use it to replace a worn or damaged guide that's causing misalignment or noisy operation. What it does

• Guides and stabilizes the blade/assembly so moving parts track correctly
• Helps reduce binding, rubbing, and abnormal noise from a misaligned assembly
• Restores proper part positioning that can prevent premature wear on adjacent components
• Useful when the existing guide is cracked, worn, or missing

• One guide blade

• Disconnect power before beginning any repair
• Remove access panels and any components blocking the guide for clear access
• Compare the new guide to the old one before installation
• Tighten fasteners to secure the guide but avoid overtightening; test operation after reassembly