General Electric Room Air Conditioner Housing Or Cover

This condenser shroud protects and channels airflow over the refrigerator condenser coils to help the system cool efficiently and keep debris away from the coils. A damaged or missing shroud can expose coils and cause noise or reduced cooling performance. What it does:

• Covers and protects the condenser coils at the rear lower section of the fridge
• Directs airflow across the condenser for efficient heat dissipation
• Helps prevent debris buildup and accidental contact with coils and fan
• Symptoms of failure: rattling or loose plastic, visible coil exposure, reduced cooling efficiency

• One condenser shroud

• Disconnect power to the appliance before starting any work
• Remove rear access panel or grille to reach the condenser area; follow OEM service instructions
• Use basic hand tools (screwdriver/socket) and support the unit if required
• Take care around sharp condenser fins and wiring; replace mounting screws if damaged

This cap clamp secures a wire terminal cap or boot to appliance wiring, helping keep electrical connections stable and aligned for reliable component operation. It's a small but important retainer used where terminal caps are present. What it does:

• Holds a protective cap/boot onto a wire terminal so the cap won't slide off during use or vibration
• Helps prevent loose connections that can cause intermittent operation or arcing at the terminal
• Keeps wiring organized at terminal blocks and component connectors
• Useful when a worn or damaged retainer allows caps to shift or expose metal contacts

• Disconnect power to the appliance before inspecting or replacing wiring components
• Use needle-nose pliers to fit the clamp over the cap/terminal; avoid pinching wires
• After installation, restore power and verify the related component powers and operates normally

Protect and refresh your control panel with this temperature control cover. It shields the temperature-control opening, supports the knob for smooth adjustments, and restores a clean appearance when the original cover is cracked or missing.

• Covers and protects the temperature/thermostat control opening on the control panel
• Provides proper seating and alignment for the control knob or dial
• Helps keep dust and debris out of the control cavity
• Common signs it's needed: broken, warped, or missing cover; wobbly knob; exposed controls

• Disconnect power before servicing
• Pull off the control knob; remove grille/trim as needed to access fasteners or tabs
• Remove the old cover; position and secure the new cover as designed
• Reinstall knob and panels; restore power and test control operation

A motor angle assembly that secures and positions the motor inside the appliance, keeping the motor aligned and stable for reliable operation. Replaces worn or bent motor mounts to reduce vibration and misalignment. What it does:

• Supports and anchors the motor to the appliance chassis so the motor stays properly aligned.
• Helps maintain correct belt or pulley alignment for smooth operation.
• Reduces motor movement that can cause vibration, noise, or premature wear.
• Restores proper motor positioning after impact or mounting-plate damage.

• Disconnect power before beginning any repair to avoid shock or injury.
• Basic panel removal and access to the motor area are typically required; keep track of all fasteners.
• Inspect adjacent mounting hardware, bushings, and fasteners and replace any damaged parts.