Jade Control Board

This electronic control board kit is the appliance's central controller, coordinating inputs and powering key components. Replacing a failed board restores proper operation, responsive controls, and reliable cycle management. What it does:

• Manages timing and power to motors, valves, heaters, fans, and other loads
• Interprets sensor and user-interface signals to start, run, and end cycles correctly
• Common failure signs: dead or unresponsive controls, cycles that won't start/finish, repeated error codes, or intermittent operation
• Helps address issues caused by power surges or board damage

• 1 electronic control board (module)

• Disconnect electrical power to the appliance; turn off gas/water if applicable
• Use ESD protection and handle the board by its edges
• Photograph wiring; transfer connectors one at a time and match any jumpers/DIP-switch settings from the original board
• Restore power and perform any model-specific tests or programming per OEM instructions

This power supply board converts household AC into the low-voltage DC your refrigerator's electronic controls require. Replacing a failing module can restore power to the display and control circuitry.

• Converts incoming AC power to regulated low-voltage DC for control electronics
• Powers the main control, user interface, and other low-voltage components
• Intermittent operation or no cooling may occur when the control system loses power

• Disconnect power from the refrigerator before servicing
• Handle the board by the edges and use anti-static precautions
• Access location varies by model; remove necessary covers/panels to reach the board
• Photograph wiring and move connectors one at a time; ensure all plugs are fully seated before restoring power

This compressor board kit replaces the compressor's control board to restore reliable compressor start and run behavior. It helps address compressor start failures and intermittent cooling so the appliance can return to normal operation. What it does:

• Replaces the compressor control/relay board that manages compressor startup and operation.
• Can stop or reduce symptoms such as the compressor not starting, repeated clicking/humming, or intermittent cooling.
• Provides the electrical interface between the compressor and the appliance power/control circuits.
• Helps isolate electronic control failures from mechanical/sealed-system issues.

• Disconnect power to the appliance before beginning any service.
• Handle the circuit board by its edges and avoid static discharge; use basic hand tools.
• Verify harness and connector compatibility with the appliance before installing.