Jenn-Air Cooktop Switch

Color: Black. Instruction sheet included.

Fix burners that won't light or spark inconsistently with this cooktop spark igniter switch. Restores reliable ignition on gas burners. Takes 15 minutes to install.

Fixes burner that won't heat or stays on one temperature. This infinite switch restores variable heat control to your cooktop surface element.

This relay change kit replaces the failed relay assembly that controls motor or compressor power, restoring proper electrical switching for normal operation. Use this kit to replace a worn or intermittently working relay with an exact-fit factory component. What it does

• Switches power to the motor/compressor when the appliance calls for it
• Restores reliable start and run signals when a relay has failed or sticks
• Addresses symptoms like clicking on start, no motor/compressor operation, or intermittent runs
• Helps prevent damage from repeated failed start attempts

• One relay change kit

• Disconnect power before servicing to avoid shock or damage
• Replace only with the exact OEM relay kit for safe, reliable operation
• Verify wiring and connectors are secure and undamaged before restoring power

For switch mounting nut, order part# WP422617.

This is a spark ignition switch used on gas ranges and cooktops to detect burner position and activate the igniter when the knob is turned. It sends a signal to the spark module to generate the electric spark that lights the gas burner. Replace this switch if a burner fails to spark when turned on, sparks continuously even after the flame is lit, or if the igniter clicks but won't stop.

This right-side burner switch controls heat output on the cooktop so burners respond correctly to your knob settings. It restores proper power and temperature control for a single right-side heating element. What it does:

• Replaces a worn or faulty right burner control to restore variable heat settings
• Enables proper on/off function and temperature regulation for the right cooktop element
• Commonly used when a burner won't heat, only works at certain settings, or cycles unexpectedly
• Works with ranges that use a separate switch for the right front/right rear heating element

• Disconnect power at the breaker before attempting any repair to avoid shock
• Handle wiring terminals carefully; verify connections match the original before reassembly
• Use proper tools and avoid overtightening mounting hardware to prevent damage

If your cooktop burner won't heat, stays on one setting, or heats erratically, this control switch regulates power to restore proper temperature selection.

Fix a burner that won't heat or won't turn off with this cooktop burner control switch. Most DIYers complete this repair in under 30 minutes.

This rotary control switch replaces a worn or failed selector used to change cycles or settings on compatible appliances, restoring reliable user input and exact position selection. Easy-to-replace direct-fit control component. What it does:

• Sends a user-selected position to the appliance control so the unit runs the chosen cycle or setting.
• Replaces a cracked, loose, or non-responsive control shaft or knob interface.
• Stops intermittent or no-response issues when turning the control knob.
• Restores tactile click/position feedback for accurate selection.

• Disconnect power before service to avoid shock risk.
• Access may require removing the control panel.
• Handle the switch and control shaft carefully to avoid damaging terminals or alignment tabs.

This is a small micro-switch used in the grill module fan circuit of a range. It detects the position or state of the fan assembly and signals the control board to activate or deactivate the fan as needed. Replace this switch if the grill fan fails to turn on or off properly, or if the switch is visibly damaged or no longer clicks when actuated.