Kenmore Elite Range / Cooktop / Oven Parts

The Grate Set is an OEM part for Frigidaire ranges. This part provides a stable surface for cookware and allowing for even heat distribution during cooking.

Common causes of a bad grate set include prolonged exposure to high heat, heavy impact from dropping cookware, or general wear and tear over time.  

Symptoms of a bad Grate Set include:

• Visible cracks, chips, or warping of the grates
• Difficulty in balancing pots and pans on the grates
• The grates not fitting properly over the burners
• Uneven cooking due to unstable grates

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Burner orifice controls gas and air flow to cooktop burners. Replace if cracked, corroded, or when converting between natural gas and propane fuel types.

LP orifice kit for gas range bake and broil burners. Includes conversion orifices to switch from natural gas to liquid propane. Replace when missing.

Gas burners won't ignite or igniter clicks continuously? The spark module generates the electrical spark to light burners. Direct plug-in repair.

Leveling leg assembly installs at the front corners of your range. Replace if broken, rusted, missing, or no longer adjusts to level your appliance.

If your burner won't turn off or stays on high heat, this surface burner switch restores proper temperature control. Straightforward 30-minute repair.

This is a 1450-watt hidden bake element located beneath the floor of the oven cavity. It provides the primary heat source for baking and roasting. Replace this element if the oven is not heating from the bottom, takes too long to reach temperature, or cooks food unevenly.

Replace your range oven door gasket to prevent heat escape and maintain proper temperature. Snaps into place with embedded clips. Confirm fit by model.

Burner not heating or stuck on? This surface element switch controls power to individual cooking elements. Moderate DIY repair requires lifting cooktop.

Loud grinding or rattling from your oven? A damaged convection fan blade disrupts airflow. This replacement restores quiet operation in 20-30 minutes.

This is an oven bake igniter that mounts inside the oven compartment near the bake burner. It draws electrical current to heat up and open the gas valve, allowing the bake burner to light. Replace this part if your oven takes a long time to heat up, doesn't reach the set temperature, or fails to ignite at all.

This surface burner ignitor/orifice assembly directs gas through a calibrated orifice and provides the spark to ignite it. Replacing a worn or damaged assembly restores consistent lighting and an even flame on the affected rangetop burner.

• Routes gas from the valve through the orifice to the burner head
• Positions the ignitor for reliable sparking and quick ignition
• Helps maintain correct flame size and pattern on that burner
• Common symptoms: burner won't light, clicks without flame, delayed ignition, weak or uneven flame

• Disconnect power and shut off the gas supply before servicing
• Remove grates, caps, and burner heads; lift the cooktop to access the assemblies
• Note wire routing and original orifice location; transfer any reusable hardware from the old part
• After installation, restore gas and check connections for leaks, then test spark and flame

Fix F10 error codes, blank displays, or temperature fluctuations. This oven control board restores bake/broil cycles and keypad response in your range.

Burner orifice regulates gas flow to your range burners. Replace if clogged with debris, corroded, or damaged to restore proper combustion and heat output.

Replace cracked, shattered, or broken door glass on your range or oven. This glass panel installs in the door assembly to provide insulation and visibility.

Fix a broil burner that won't light or clicks repeatedly. This spark electrode generates the ignition spark needed for reliable broil operation.