Kenmore / Sears Ice Machine Parts

• Ice maker not making ice
• Ice maker won't dispense ice
• Leaking

Much easier than expected, I was certain it had to be a water line but the solved everything Read more

• Ice maker not making ice

I used your online troubleshooting tips and watched the videos on your site. I determined my thermostat was defective, ordered the thermostat which arrived in two days and I replaced the thermostat and I now have a full bin of ice !!! The do it yourself video was extremely helpful and made the repair very easy. Thanks so much for the great service and quick delivery !!! Read more

Replaced It With New One Read more

Order a new bin thermostat and replaced the old one and it seems to be working fine. Thanks Read more

This was a fairly easy process. 1) Tighten one of the wire ends to a screw and keep the wire as taut as possible while wrapping it through the grid. Brace the grid against a corner wall, or held within a vice (don't over tighten in this instance). 2) Be sure to have the second screw ready to tighten, and again, keep the wire taut as you wrap it around this screw. It may take some re-wrapping to eliminate slack. 3) After the lower wrapped section is complete, repeat for the upper wire... Read more

Noticed that some terminals on the wiring harness were corroded and that no water was being pumped over the ice grid. Ice machine did get cold inside the compartment so it was not apparent that the compressor was bad. Ordered a Water Pump (from bin to ice grid) and a new wiring harness. Recirculating pump appeared to be okay. As I am not an experienced service tech (actually a Chemist) logic told me that my chances of success were high (not guaranteed though).. After replacing the parts... Read more

I replace the water inlet valve in my refrigerator about 8 months ago. About a week ago, the old plastic water line broke. I forgot how the water line connector worked and broke the valve trying to pull it out. I got a new valve and replacement water line, and it went in easily, just like the video said. Morals of the story: 1. Know how to remove the old plastic water line. I could have saved myself the price of a new valve if I'd remembered how the connector worked. Unless you have a really... Read more

Ordered new circuit board and water pump. Hired a professional to install them Read more

There are plenty of DIY youtube videos to show you how to replace the parts. I went ahead and replaced more than just the broken parts. I figured if I had the machine opened up, I might as well replace parts that could go out in the future. I might have gone a bit too far with all the other parts. The only part that was really broken was the wiring harness. Two of the wires had corroded from the sockets and there was no other way than to replace the entire harness. Its a bit tricky to feed... Read more

There are plenty of DIY youtube videos to show you how to replace the parts. I went ahead and replaced more than just the broken parts. I figured if I had the machine opened up, I might as well replace parts that could go out in the future. I might have gone a bit too far with all the other parts. The only part that was really broken was the wiring harness. Two of the wires had corroded from the sockets and there was no other way than to replace the entire harness. Its a bit tricky to feed... Read more

Replaced grid wire harness. only difficulty was keeping the grid wire tight while attaching harness to grid. Read more