Kenmore / Sears Range / Cooktop / Oven Wire, Harness, Power Cord

This harness module connects and routes electrical signals between components to restore reliable circuit connections and control communication. It replaces a damaged or worn module to help appliances power and operate correctly. What it does:

• Routes power and signal connections between internal components to ensure consistent electrical continuity
• Replaces broken, frayed, or corroded wiring that can cause intermittent operation or loss of function
• Helps resolve symptoms such as lights or controls not responding, intermittent cycles, or non-start conditions when traced to the harness
• Maintains correct connector fit and pin alignment for secure component mating

• One harness module as shown

• Disconnect power before servicing to avoid shock or damage
• Inspect connectors and mating components for damage or corrosion before installation
• Secure harness away from sharp edges and moving parts; follow OEM routing and fastening points

Wire harness that connects the control valve to the oven's electrical system. Replace if wires are frayed, connectors are damaged, or harness is broken.

Splicing 25 Ft. Black 12 Ga. 150~c (Wire, Red 14 Ga. 200~c)

This main wiring harness routes power and control signals between an appliance's control board and its components so switches, sensors and motors can operate reliably. It replaces a damaged or faulty harness to restore proper electrical connections. What it does:

• Provides factory-style connector plug-and-play connections between control electronics and components
• Replaces frayed, burned or broken wiring that can cause intermittent operation
• Restores lost or intermittent power to controls and motors when harness damage is the cause
• Helps eliminate blown fuses or tripped breakers caused by shorted or exposed wires

• Disconnect all power (unplug appliance or shut off breaker) before starting any work
• Compare connectors and wire routing to the original harness to ensure correct fit
• Route harness along original clips and retainers; avoid sharp edges and hot surfaces
• Inspect connectors for corrosion; secure with cable ties as needed and test appliance after reconnection