Kenmore / Sears Range Handle

We ordered a new handle and two screws. The part was very easy to find and was in stock. Shipped out in 2 days and delivered by fed -ex. My teenage son put the handle on in less than 5 minutes. very easy. So happy we can finally use the oven again. Read more

I removed end caps installed one end cap fitted handle to this end cap then fitted 2nd end cap to handle then attached this end cap to stove door. Read more

Replaced handle after watching your repair video. Read more

Replaced with new part Read more

I used the new screws; which were about 1/4 inch longer then OEM for better engagement, and with Phillips screw driver attached the handle. Read more

Separated oven door by removing screws. Inserted handle and secured with clips, and reassembledo door with screws provided. In served broiler handle and snappedal into place. Read more

Removed side moldings top molding and glass, removed broken handle. Reinstalled new handle, all modings and glass. Read more

Just screwed on the new handle. The new handle did not come with threaded holes, but this was OK because the screws that came with the stove were self tapping. This takes a bit more effort and the proper screwdriver, but creates the threads in the handle as you turn the screw. Kudos to A-P Pros for the quick processing and delivery of the order. Read more

Replaced with a new handle Read more

Parts arrived on time. All fit as expected. Read more

I orderd parts you said I needed, but all I needed was a handle. I will keep other parts for future needs Read more

I ordered the replacement handle and replaced it myself. Read more

Replacing the trim takes a little bit of alignment and light force. The trim slides over the glass panel of the door, with the glass sliding into plastic tabs. We kept the door nearly vertical (almost closed), lined up the tabs on the trim with the glass door, and used mild force to slide the trim down onto the glass door. (Also, we found that the tabs on trim we ordered were much bigger than the tabs on our broken trim. This is probably due to slight variations in Frigidaire's design over... Read more

Open door, removed the two large screws in the inside corners, take the middle white piece and lined the holes up on the door and handle, inserted screws, put all layers of door back together and reinserted large corner screws. done, easy peasy!!!! Read more