Kenmore / Sears Range Trim

I used the oven model number to find the replacement parts online and Appliance Parts Pros had the parts I needed at the lowest cost compared to other online retailers. This repair only required a screwdriver, but it took time to figure out where everything belonged since the oven instruction manual was not very informative for a do-it-yourself fix. Read more

Initially, I took it off, sanded it and painted with appliance touch-up. Still didn't look good so I ordered a replacement part and installed. Read more

I am plagiarizing some info from the techs.. 1. Turn off the electrical supply to the range. 2. Remove the oven door and position it on a protected floor or "truck tailgate".(here I googled, "removing oven door on super capacity 465" ...my model had clips at the hinge that I had to pop out)... lay down the handle and outer door glass facing up. 3. Raise the top of the door and remove the two screws that secure the top of the door trim and the handle to the door liner, then remove the handle and... Read more

Kit arrived promptly. it took help of a friend and 45 minutes to install Read more

I had to order the glass, frame, and cap that the handle attaches to. I just had to put in about 6 screws, it was very simple. Read more

Had to order new plastic panel, scared to run the clean cycle again. Read more

I had to order the glass, frame, and cap that the handle attaches to. I just had to put in about 6 screws, it was very simple. Read more

I lifted up the door and removed it. Next, I laid out newspaper on the floor. I placed the door on the newspaper upside down. With my socket driver, I removed the bottom door trim. I then used a pocket knife to remove the remaining glass in the top groove. I then slid in the new glass and reinstalled the trim. It took 30 minutes to replace the glass and clean up the glass fragments from the previous door glass. I looked up a video on how to replace it Utube. Personal safety equipment - Safety... Read more

I replaced the faulty and damaged parts. Most of the time required was spent cleaning oven grease off of the door parts. The only hard part was removing the rusted door trim which was stuck to the glass front panel. Read more

This was an easy fix. Just needed the replacement part. Read more

Replaced the trim around the glass door on the oven.. Read more