Kenmore / Sears Range Fuse Or Sensor page 3

Genuine Whirlpool part

Kenmore Thermostat (Fixed), 1 Pack

By: Whirlpool

Part Number: 9758409

This fixed thermostat monitors and helps regulate appliance temperature to maintain safe operation and reliable cooling/heating. It replaces a worn or failed thermostat to restore proper cycling and temperature control. What it does:

Opens or closes a circuit at a set temperature to control heating or cooling cycles
Prevents continuous run by signaling the system to stop when the desired temperature is reached
Commonly used to address symptoms like no temperature control, compressor or heater running nonstop, or failure to reach set temperature
Works as a safety/control device to reduce risk of overheating when operating correctly

What's included:

One fixed thermostat

Install notes:

Disconnect power before servicing to avoid shock or injury
Locate and access the thermostat per your model's service instructions (typically mounted near the evaporator, heater, or air path)
Handle carefully and avoid bending or damaging terminals; verify function with a multimeter if equipped

More

$52.57

Compare At:: $53.38
You Save:: $0.81

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Kenmore Thermostat (Oven Lower)

5.0 (1)

By: Whirlpool

Part Number: 3149653

This lower oven thermostat regulates oven temperature for accurate baking and roasting. Replaces a failed temperature-sensing thermostat to restore consistent oven heat and reliable cooking results. What it does:

Senses oven cavity temperature and signals the control to cycle the heating element
Stops oven overheating or underheating when the thermostat is functioning correctly
Commonly replaced for inconsistent temperatures, oven running too hot/too cold, or no temperature control
Works as the lower-oven temperature regulator in ranges with separate upper/lower oven controls

What's included: One lower oven thermostat Install notes:

Disconnect power to the appliance before beginning any service
Handle the sensing bulb and capillary tube carefully; do not kink or sharply bend
Verify oven is fully cooled and remove oven racks for access before installation

Do-It-Yourself Stories from Customers like You Oven would not heat. Thomas H. • Lafayette , LA • November 06, 2017

I tested the temperature sensor with my multimeter and found it reading 2000 ohms instead of 1000. I ordered the part, installed it and saved lots of money. I was considering buying a new oven but thought I would give it a shot and with all the information available it was easy. Read more

More