Kitchenaid Blender Gasket & Seal

Kitchen Aid blender dome and blade seal. Color: black. It measures about 3 inches in diameter.

Jar lid seal for select household blenders. This flexible ring sits in the lid assembly to form a leak-resistant barrier at the top of the jar, helping keep ingredients contained and preventing drips while blending.

• Forms a tight, leak-resistant seal between the lid components and jar
• Restores proper fit when the original seal is cracked, flattened, or missing
• Typical symptoms: seepage around the lid, splatter from the top, or a lid that won't stay snug
• Normal wear can harden or deform the seal over time

• Unplug the blender and remove the jar from the base before servicing
• Remove the lid (and ingredient cap, if equipped); lift out the old seal from its groove
• Clean mating surfaces; press the new seal evenly into the groove without twisting
• Verify the seal sits flush; test with water before regular use

Color: clear. It measures about 3-1/2 inches in diameter.

This replacement seal keeps liquids and food particles out of the blender motor housing to protect internal components and help prevent leaks. Fits the motor assembly where the shaft passes through the housing. What it does

• Seals the motor shaft opening to help prevent liquid from entering the motor housing.
• Reduces risk of motor damage or shorting caused by leaks into the base.
• Helps stop leaking at the blender base or around the blade assembly when worn.
• Replace if the seal is cracked, flattened, swollen, or shows visible wear.

• Always unplug the appliance before disassembly and removal of the jar or motor housing.
• Remove the blade and jar assembly per the service diagram to access the shaft seal; inspect mating surfaces and replace damaged components.
• Ensure the new seal is seated evenly around the shaft and in its groove; do not force or over-stretch the seal.
• After reassembly, run a short water test (with the unit unplugged from any direct water source) to check for leaks before normal use.

This O-Ring is a small sealing gasket used in your appliance to create a secure, leak-resistant joint between mating parts. Replacing a worn ring restores proper sealing performance to help prevent drips, seepage, and premature wear. What it does:

• Forms a tight seal between mating components to contain fluids and protect internal parts
• Helps maintain proper system pressure and flow where used
• Reduces leaks at fittings, housings, or shafts
• Typical failure signs: visible seepage, persistent drips, or a flattened/cracked ring

• Includes one O-ring

• Disconnect power and shut off any supply lines before servicing
• Remove the old ring carefully; clean the groove and mating surfaces
• Apply a light silicone-based lubricant to the new ring
• Seat evenly without twisting; reassemble and tighten fittings without overtightening

This genuine refrigerator door gasket creates an airtight seal around the fridge door to help maintain proper temperature and energy efficiency. Replacing a worn gasket restores seal integrity and helps prevent moisture and frost buildup. What it does:

• Seals the refrigerator door to keep cold air in and warm, humid air out
• Reduces frost and moisture accumulation inside the compartment
• Helps the compressor run less often by maintaining proper cabinet temperature
• Commonly replaced when you notice air leaks, visible gaps, or a damaged/warped seal

• One door gasket (1 each)

• Inspect the cabinet flange and mounting channel for damage before installing
• Clean contact surfaces and allow gasket to warm/settle for an even fit; follow OEM seating procedure
• Replace with the door closed and check for even contact around the entire perimeter