Lg Washer Parts

This outer door frame replaces a damaged or worn exterior door trim to restore the finished appearance and structural support of the refrigerator door. It provides a clean, factory look and helps secure door components. What it does:

• Replaces cr

Cabinet base assembly for washers. Supports and encloses internal components at the bottom of the unit. Replace if cracked, rusted, or damaged.

This frame assembly is the outer trim piece that restores the appliance's finished appearance and helps hold adjacent panels or components in place. It replaces damaged or missing trim to improve fit and seal. What it does:

• Provides a finished edge and structural support for the appliance front or access panel
• Helps keep adjacent panels aligned and reduces gaps where dirt or moisture can enter
• Restores proper mounting points for switches, bezels, or door panels when the original is cracked or broken
• Commonly replaced for visible damage, warped trim, or when the frame no longer secures nearby components

• One frame assembly

• Disconnect power before starting and remove any connected water lines if applicable
• Handle trim carefully to avoid scratching the finish and to prevent personal injury from sharp edges
• Installation typically requires removing outer panels and fastening the frame with existing screws or clips; keep removed hardware for reassembly

Outer door frame for washer front-load models. Replace if your door frame is cracked, chipped, or damaged. Installs around door glass assembly.

This replacement clamp secures flexible hoses and tubing to fittings to help prevent leaks and keep connections stable. It's a small but essential part for reliable water and drain line performance. What it does:

• Holds hoses or tubes firmly to barbs, fittings, or posts to prevent disconnection
• Helps reduce leaks and water seepage at hose connections
• Minimizes rattling or vibration from loose tubing
• Supports proper routing of lines to avoid kinks or wear

• Disconnect power and water supply before starting any repair
• Use appropriate hand tools (pliers or a screwdriver, depending on clamp type) and avoid over-tightening
• Inspect nearby hoses and fittings for wear and replace if damaged

This balance weight stabilizes the washer drum to reduce vibration and keep the washer steady during spin cycles. Replacing a worn or damaged weight restores smoother operation and reduces shaking and noise. What it does:

• Adds mass to the washer frame/drum assembly so the tub stays balanced during spin
• Helps prevent excessive vibration, banging, and movement during high-speed spins
• Reduces noise caused by an unbalanced load or damaged weight
• Supports proper drum alignment to avoid premature wear on bearings and suspension parts

• One balance weight

• Always unplug the washer before starting any repair to avoid electrical shock
• Support the drum/tub when removing or installing the weight to prevent component damage
• Reuse or replace any mounting hardware only if explicitly specified by the manufacturer
• If vibration persists after replacement, inspect suspension, shock absorbers, and mounting points

Replace a cracked, broken, or missing cover cap on your laundry center. This plastic cap covers and protects internal components from debris and damage.