Parts for Whirlpool WRT359SFYW00: 02 - Liner Parts

Stops refrigerator fan rattling and buzzing noise. This rubber grommet cushions the fan motor to reduce vibration. Simple DIY fix, takes under 30 minutes.

Fix frost buildup and inconsistent cooling with a new evaporator cover gasket. This seal prevents moisture accumulation at the evaporator compartment.

Refrigerator not cooling consistently or compressor short cycling? This thermostat capillary tube shield protects temperature sensing. DIY repair.

Wire harness for refrigerators. Replaces damaged, frayed, or disconnected wiring that connects electrical components. Essential when wires are worn or broken.

Refrigerator light won't turn on? This light socket kit restores interior lighting when bulbs won't work. Simple DIY repair with video guide.

Refrigerator not cooling but freezer works? A failed evaporator fan motor stops cold air circulation. DIY repair in 30-45 minutes with basic tools.

Fridge not cooling but freezer works? A worn evaporator fan blade prevents cold air circulation. Easy 15-minute DIY fix with our video guide.

Control box housing for refrigerators. Protects electrical components and wiring. Replace if cracked, broken, or damaged to restore proper coverage.

This thermostat is a temperature-sensitive safety switch that monitors heat and opens or closes the circuit at a set point. Replacing a failed thermostat restores reliable temperature protection and corrects issues caused by tripping or stuck contacts.

• Monitors component/cavity temperature and trips at a preset limit
• Opens (or closes) the electrical circuit to prevent overheating or activate cooling functions
• Common symptoms: no heat or intermittent heating, unit won't start or shuts off during use, cooling/vent fan runs constantly or never turns on
• Useful diagnostic clue: faulty thermostats may test open or stuck closed at room temperature

• Disconnect power at the breaker before servicing; if used in a microwave, be aware the high-voltage capacitor can retain a dangerous charge
• Note wire locations; transfer one lead at a time and secure the thermostat in the original mounting position for proper sensing
• Ensure clean metal-to-metal contact with the mounting surface; do not overtighten screws
• After installation, restore power and verify normal operation

Plastic cap for freezers, ovens, and refrigerators. Replaces cracked, broken, or missing caps. Direct fit component for secure installation.

Refrigerator light won't turn off or on? The door switch detects when the door opens and closes. Easy 5-minute DIY repair with a pick tool or scraper.

Replacement wire harness for refrigerators. Connects electrical components inside your unit. Order when wires are damaged, frayed, or corroded.

Fix dim or uneven refrigerator lighting with a new air diffuser light cover. Shields the bulb and directs light evenly. Simple 5-minute replacement.

Replacement screw that secures panels, brackets, and trim to appliance cabinets. Restores reliable hold when original hardware is stripped or missing.

Fix a refrigerator not cooling or ice buildup on evaporator coils with this defrost thermostat. Moderately easy install, typically 1-2 hours.

This orifice is a small precision component used in the refrigerator's cooling system to regulate refrigerant or gas flow. It is typically located near the evaporator or cooling circuit and helps control the rate at which refrigerant enters the evaporator coil. Replace this part if the refrigerator or freezer section is not cooling properly, frost patterns are uneven, or a technician has identified a restricted or damaged orifice during diagnosis.

This is a metal heat shield designed to protect internal components from excessive heat inside the refrigerator or freezer compartment. It acts as a thermal barrier, typically installed near the defrost heater or compressor area, preventing heat damage to surrounding parts. Replace this shield if it is warped, corroded, or missing, which can lead to uneven cooling or frost buildup.

Size: 8-18 x 1/2 inch.

Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.

Secures internal components in your refrigerator to keep parts stable and prevent rattling. Replace if bent, broken, or missing to restore alignment.

White hole plug covers unused openings in your refrigerator cabinet. Replace when missing or damaged to seal gaps and protect internal components.

Fix ice maker or water dispenser issues with this valve tube body. Routes water from the main valve to dispenser and ice maker. Stops leaks from damaged tubes.