Parts for Dcs RGB-305: Lower Gas Train Parts

This tubing manifold/regulator directs and regulates flow between the appliance inlet and internal components, helping restore proper delivery and performance. Replace a damaged or leaking manifold to stop leaks and regain normal operation. What it does:

• Routes and controls fluid flow through connected tubing to downstream components
• Helps maintain consistent delivery to valves and assemblies
• Common replacement for visible leaks, loose/broken tubing connections, or disrupted flow
• Supports restoring normal appliance performance after manifold damage

• One tubing manifold/regulator

• Disconnect power and shut off the appliance supply (water or gas) before starting
• Inspect tubing and fittings; replace any damaged hoses or clamps when needed
• Tighten fittings to manufacturer torque recommendations and check for leaks after installation

This 1/2" shut-off valve stops or restores water flow to the appliance, letting you isolate the supply for repairs or to stop leaks quickly. It's a direct-replacement service valve used on compatible Fisher & Paykel units. What it does:

• Controls water flow to the appliance supply line so you can turn water on or off at the appliance.
• Helps isolate the appliance for maintenance, repair, or replacement of hoses.
• Common symptom: water continues to flow or cannot be shut off at the appliance supply.
• Common symptom: leaking or dribbling at the supply connection that requires valve replacement.

• Turn off the household water supply and relieve pressure before replacing the valve.
• Use appropriate plumbing tools and thread sealant or tape where required; avoid over-tightening fittings.
• Inspect supply lines and fittings for damage and replace if corroded or worn.

This is a pack of #10 x 3/8 inch Phillips truss-head screws with nickel plating for appliance fastenings. Use them to replace missing or corroded trim and panel screws and restore secure mounting and fit. What it does:

• Fastens trim, panels, brackets and light-duty components where #10 x 3/8 in screws are specified
• Truss head provides a larger bearing surface to reduce pull-through on thin materials
• Phillips drive offers easy, common-driver installation
• Nickel plating resists corrosion for longer-lasting fit in humid areas
• Replacing worn or missing screws can stop rattling, loose panels, and misaligned parts

• Ten #10 x 3/8 in Phillips truss-head nickel-plated screws

• Use the correct-sized Phillips driver to avoid cam-out and damaged heads
• Tighten until snug—do not overtighten to prevent stripping or distorting thin panels
• Disconnect power and remove any panels per appliance instructions before servicing
• Wear safety glasses and keep small parts away from children and pets