Parts for Dcs RGB-305: Oven Parts

Replacement oven rack bracket for gas ranges. Mounts inside the oven cavity to support and secure racks. Needed when original is bent, broken, or missing.

This is a pack of #10 x 3/8 inch Phillips truss-head screws with nickel plating for appliance fastenings. Use them to replace missing or corroded trim and panel screws and restore secure mounting and fit. What it does:

• Fastens trim, panels, brackets and light-duty components where #10 x 3/8 in screws are specified
• Truss head provides a larger bearing surface to reduce pull-through on thin materials
• Phillips drive offers easy, common-driver installation
• Nickel plating resists corrosion for longer-lasting fit in humid areas
• Replacing worn or missing screws can stop rattling, loose panels, and misaligned parts

• Ten #10 x 3/8 in Phillips truss-head nickel-plated screws

• Use the correct-sized Phillips driver to avoid cam-out and damaged heads
• Tighten until snug—do not overtighten to prevent stripping or distorting thin panels
• Disconnect power and remove any panels per appliance instructions before servicing
• Wear safety glasses and keep small parts away from children and pets

Replace your range oven light assembly when the bulb won't illuminate or the fixture is damaged. Restores interior visibility for safe cooking. Verify fit with your model number before ordering.

Phillips head screw kit for securing panels and components in electric wall ovens, gas ranges, and ranges. Replace missing, stripped, or damaged screws.

This replacement rack support bracket secures and guides a dishwasher rack so the rack stays aligned and slides smoothly. Installs quickly to restore proper rack tracking and prevent sagging or derailment. What it does

• Holds the rack in place and guides its sliding motion along the track
• Prevents the rack from sagging, tilting, or coming off the track during use
• Helps stop noisy or rough rack movement caused by a broken or worn bracket
• Restores proper rack alignment for consistent loading and unloading

• Disconnect power to the appliance before starting work; for dishwashers also turn off water at the supply if required.
• Remove the affected rack to access the bracket; keep track of any clips or screws removed.
• Use basic hand tools (screwdriver or nut driver) as needed; follow OEM diagram orientation for correct placement.
• Replace damaged mounting hardware before finishing reassembly.

Oven not heating properly or baking unevenly? This bake burner generates heat for consistent baking performance. Direct replacement part for gas ranges.

Oven won't heat or takes too long to ignite? This gas range igniter lights the burner. Common failure causes include cracked ceramic or corrosion.

Stainless steel mounting screw for gas grills, ovens, and ranges. Replaces damaged, stripped, or missing screws used to secure panels and components.