Parts for Dcs RGB-305: Structure Parts

This is a pack of #10 x 3/8 inch Phillips truss-head screws with nickel plating for appliance fastenings. Use them to replace missing or corroded trim and panel screws and restore secure mounting and fit. What it does:

• Fastens trim, panels, brackets and light-duty components where #10 x 3/8 in screws are specified
• Truss head provides a larger bearing surface to reduce pull-through on thin materials
• Phillips drive offers easy, common-driver installation
• Nickel plating resists corrosion for longer-lasting fit in humid areas
• Replacing worn or missing screws can stop rattling, loose panels, and misaligned parts

• Ten #10 x 3/8 in Phillips truss-head nickel-plated screws

• Use the correct-sized Phillips driver to avoid cam-out and damaged heads
• Tighten until snug—do not overtighten to prevent stripping or distorting thin panels
• Disconnect power and remove any panels per appliance instructions before servicing
• Wear safety glasses and keep small parts away from children and pets

Right side

The Leveling Leg is an OEM component specifically designed for Fisher & Paykel ranges. Each leg is important in properly elevating and balancing the range for safe and efficient operation.

The leveling legs are responsible for fine-tuning the range's placement and adjusting to uneven surfaces. They ensure the appliance sits firmly and remains stable during cooking. 

Symptoms of a bad leveling leg include:

• The range rocking or wobbling excessively       
• Difficulty opening or closing oven/cooktop doors and drawers
• Poor balance affects functionality and can damage other components

Causes of a bad leveling leg can be wear and tear over time, damage from overtightening, or minor accident impacts.

This OEM Fisher & Paykel replacement part is compatible with some Kenmore and KitchenAid ranges.
 

A pack of ten 10-32 x 5/8 inch pan head Phillips machine screws with zinc finish, used to fasten appliance panels, brackets, and components. Durable, service-grade screws for routine appliance repairs and reassembly. What it does:

• Secures panels, trim, brackets and internal components where 10-32 machine screws are specified.
• Replaces missing or stripped screws that cause loose panels or rattling.
• Restores proper fit and alignment after service or component replacement.
• Zinc plating helps resist corrosion in normal household conditions.

• Ten 10-32 x 5/8 in pan head Phillips machine screws with zinc finish.

• Use the correct size Phillips driver to avoid cam-out and head damage.
• Start screws by hand to ensure proper thread engagement; do not cross-thread.
• Tighten snugly but avoid overtightening to prevent stripping threads or damaging parts.
• Disconnect power and follow appliance safety procedures before servicing.