Bosch Washer WFC41250TI Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Replace your washer door seal if you notice water leaking during wash cycles. This rubber boot creates a watertight barrier between drum and door. Confirm fit with your model number.

The Carbon brush, drum motor is an OEM part for Bosch washing machines. These carbon brushes are responsible for transferring electrical current from the commutator on the motor to power the rotary movement inside the washing machine drum.  Two come per package.

Symptoms of a bad carbon brush, or drum motor can include:

• noisy or squealing sounds coming from the motor during the operation  
• the drum fails to spin or spin inconsistently
• the washer is unable to enter spin cycles
• slow or reduced agitation 

Causes of a bad part include normal wear and tear over extended use. As the brushes continuously contact the commutator, friction can cause them to wear down over time.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

Wire clamp spring that secures the door boot to the washer's front panel opening. Replace if broken, stretched, or missing to keep the seal properly seated.

Replacement door hinge for front-load washers. Supports door weight and enables smooth opening/closing. Replace if cracked, broken, or causing door sag.

The Washer Filter-Fluff is an OEM replacement part for Bosch washing machines. It is a critical component responsible for capturing lint, debris, and other particles that may accumulate during the wash cycle, preventing them from clogging the drainage system or causing damage to the machine.

Over time, the accumulation of lint and debris can impede the filter's effectiveness, leading to drainage issues and reduced washing performance. Physical damage to the filter can also compromise its ability to capture lint properly.

Symptoms of a bad washer filter-fluff include:

• Slow or incomplete draining of the washing machine
• Excessive lint on clothes after washing
• Unusual noises during the drain cycle
• Error codes related to drainage issues

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore washing machine models. 

Secures the washer door handle to the door assembly. Replace if worn, bent, broken, or missing to restore a firm grip and prevent handle detachment.

Front drum motor mounting bushing for washers. Supports the drum shaft for smooth rotation. Replace if worn, cracked, or causing misalignment issues.

Secures the drum pulley to the washer's drive system. Replace this bolt if it's stripped, missing, or loose to properly fasten the pulley assembly.

Secures the front counterweight to the washer drum. Replace if strap is cracked, broken, worn, or missing to restore proper weight distribution.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Secures rotating components in your washer to prevent movement and vibration. Replace if parts feel loose or noisy. Confirm fit with your model number.

This cover protects internal components and provides a finished appearance. Replace if cracked, broken, or missing to restore proper enclosure.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Coupling that connects the program knob to the timer mechanism on your washer. Replace if cracked, stripped, broken, or missing for proper cycle selection.