Kenmore Refrigerator 106.50552000 (10650552000, 106 50552000) Parts

This is a replacement wire harness that restores electrical connections between components so your appliance powers and controls operate correctly. It provides the factory-style wiring needed for reliable signal and power routing. What it does

• Carries power and control signals between major components so circuits can operate as intended
• Commonly used when damaged, melted, cut, or corroded wires cause intermittent operation or loss of function
• Can resolve symptoms such as components not receiving power, control buttons or lights not responding, or erratic behavior due to open/shorted wiring
• Matches OEM routing and connector ends to maintain original fit and connections

• One complete wire harness assembly as shown

• Disconnect all power (unplug or shut off breaker) before starting any repair
• Note wire routing and connector locations or take photos before removal to ensure correct reassembly
• Inspect connectors and mounting clips; replace any broken retainers to prevent chafing or strain

A roll pin (spring pin) that secures rotating or sliding components by fitting into matched holes to hold shafts, levers, or brackets in place. Replaces a worn or damaged pin to restore proper mechanical engagement. What it does:

• Holds shafts, levers or hinges in position by expanding into drilled holes for a snug, vibration-resistant fit
• Keeps pulleys, rollers, or linkages from moving out of alignment or sliding off their shafts
• Common symptom: loose or wobbling pulley, lever, or shaft where the retaining pin is worn or broken
• Common symptom: noisy or intermittent operation caused by a pin that no longer secures moving parts

• Inspect mating holes and shaft for wear; replace pin with correct size to ensure secure fit
• Use appropriate pliers or a pin punch and hammer to drive the pin in or out; support the assembly to avoid damage
• Wear eye protection when installing or removing roll pins—pins can snap or fly out under force
• If pin is difficult to remove or install, consider using penetrating oil or heating only per OEM guidance

Color: White. Size: 1 qt. can. Acrylic appliance paint.

This front cover is the outer panel that restores the appliance's appearance and protects internal components and controls from dust, debris, and accidental contact. It provides a clean, finished look and secures front-facing assemblies. What it does:

• Protects control components and internal parts from dust and impact
• Restores the appliance's front appearance when the original cover is cracked, dented, or faded
• Helps reduce drafts and keeps internal components properly enclosed
• Can stop rattling or interference caused by a loose or damaged front panel

• Disconnect power (and gas if applicable) before beginning any work.
• Handle carefully — edges may be sharp; use gloves to protect your hands.
• Removal/installation typically requires removing screws or fasteners and may involve detaching the control console or trim; keep fasteners organized.

This front cover trim panel replaces a damaged or worn front-facing panel to restore the appliance's appearance and protect internal components. It provides a clean finished look and helps keep dirt and debris out of the cabinet. What it does

• Shields internal controls and components from dust and spills.
• Restores a secure mounting surface for the control and door area.
• Helps stop rattling or scraping caused by cracked or loose front panels.
• Improves the appliance's original appearance after cosmetic damage.

• One front cover trim panel.

• Use basic hand tools; disconnect power and water before starting.
• Follow factory service manual steps for panel removal and reattachment to avoid damaging clips or fasteners.
• Replace any broken clips or screws found during disassembly.

8 x 1/12