Kenmore Refrigerator 106.50564991 (10650564991, 106 50564991) Parts

Ice not dispensing properly or spilling? This crusher housing secures ice-crushing components and guides crushed ice to the chute. Fixes cracked housings.

Secures the control box assembly in your refrigerator. Replace this clip if it's broken, cracked, or missing to properly mount the control housing.

Replacement shelf support track for refrigerators. Guides shelves to slide smoothly in and out. Replace if cracked, broken, or worn to restore alignment.

Fix uneven cooling and warm spots in your refrigerator with this air baffle. Directs cold air properly throughout compartments. Simple DIY fix.

Support frame for refrigerators. Mounts internally to provide structural support. Replace if cracked, broken, or damaged to restore proper alignment.

This is a metal mounting rail used to secure the compressor unit to the base of the refrigerator. It provides stable support and helps reduce vibration during compressor operation. Replace this rail if it is bent, cracked, or corroded, or if you notice excessive vibration or unusual noise coming from the bottom of the refrigerator.

Secures and organizes wire harnesses inside your refrigerator. Replace this clip if it's cracked, broken, or missing to properly route electrical wiring.

Protective wiring cover cap for refrigerators. Shields electrical connections from dust and damage. Replace if cracked, broken, or missing.

This front cover is the outer panel that restores the appliance's appearance and protects internal components and controls from dust, debris, and accidental contact. It provides a clean, finished look and secures front-facing assemblies. What it does:

• Protects control components and internal parts from dust and impact
• Restores the appliance's front appearance when the original cover is cracked, dented, or faded
• Helps reduce drafts and keeps internal components properly enclosed
• Can stop rattling or interference caused by a loose or damaged front panel

• Disconnect power (and gas if applicable) before beginning any work.
• Handle carefully — edges may be sharp; use gloves to protect your hands.
• Removal/installation typically requires removing screws or fasteners and may involve detaching the control console or trim; keep fasteners organized.

This front cover trim panel replaces a damaged or worn front-facing panel to restore the appliance's appearance and protect internal components. It provides a clean finished look and helps keep dirt and debris out of the cabinet. What it does

• Shields internal controls and components from dust and spills.
• Restores a secure mounting surface for the control and door area.
• Helps stop rattling or scraping caused by cracked or loose front panels.
• Improves the appliance's original appearance after cosmetic damage.

• One front cover trim panel.

• Use basic hand tools; disconnect power and water before starting.
• Follow factory service manual steps for panel removal and reattachment to avoid damaging clips or fasteners.
• Replace any broken clips or screws found during disassembly.

8 x 1/12

Includes door, support, spring and mechanism delay. No longer uses the ribbon heater due to the improved foam design. If your refrigerator uses this ice door kit and the mounting tabs are broken you can use the broken tab ice door kit 8201756.