Kenmore Refrigerator 106.57879801 (10657879801, 106 57879801) Parts

Replaced both sets of door cams on my Kenmore Elite Refrigerator. The most important thing to know is that you DO NOT have to remove the doors from the refrigerator to replace BOTH sets of cams. You just have to remove the lower grill which is a snap fit (I also turned off the water and unplugged the unit). My fridge has an ice and water dispenser where the water and electrical lines go through the cams on the left side. Be sure to order the correct parts as the cam holes on the freezer side... Read more

Removed broken crisper drawer , had to remove a sliding humidity control slider that was snapped in, and another slide attatched to handle of drawer , my grandon did both for me and the new crisper pan was put in place Delivery was 3 days , could of been quicker if I choose but it was not an emergency repair . It was package well also and best part the price was 25% lower than Sears ! Read more

I had to remove a metal panel at the bottom back of the freezer as well as a couple of shelf slides in order to get at a drain pan in the back. It was frozen solid, so I stabbed at it with an ice pick until I broke through, followed up by poking a coat hanger in the drain hole to clear as much as I could, then poured a little boiling water over it to follow up. After screwing it all back together, the ice maker surprisingly was working again in less than 20 minutes. I also replaced a broken... Read more

So easy to replace the Diffuser, in less than 5 minutes. Read more

• Light not working

We actually were able to determine that one of the freezer switches was bad and taped it down for about 3 days. The beeping stopped. Our fridge has two freezer switches and one fridge side switch. I ordered all three from these guys. They were cheaper than Whirlpool by about $20 for parts and about $15 for shipping. The part numbers had superseded too many times to count, usually that doesn't matter but in this case it did. The new parts were just slightly bigger than the old parts AND... Read more

The water dispenser stopped working on my Sears Kenmore (Whirlpool) side-by-side refrigerator and after much research on the web I purchased the parts that commonly failed for this condition. I should have first taken the dispenser assembly apart but I didn't--it looked a little too intimidating to do twice. As it turns out, what actually broke was the plastic assembly that holds the water actuator switch in place so the dispenser lever could not strike it. I was able to secure it in place... Read more

Replaced It With New One Read more

Ordered a shelf for the refrigerator and a shelf for the freeze compartment. Adding the shelf to each side was easy. Job completed. Parts were ordered on line, they arrived in 2 days. Read more

I got online and found the egg carton case for my refrigerator - ordered it - it arrived and was exactly what I wanted. Online shopping is AMAZING!! Read more

After being told by a service repairman that it would cost me close to $200 to repair, I resolved to just not use the dispenser. After about a year, I had decided that I wanted to repair it and would look at the options myself. At the least, I could figure out which parts were needed to repair it and have them on hand for a service guy if I determined I could not do the job myself. The more I studied it, the more I felt confident that I could do it, and sure enough, when the part arrived - a... Read more

Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more

Very nice sales representive, very helpful, polite, and very professional.., and super fast service. Ordered shelf and was on my door step in two days. I thought the price was high, but, then so is everything else these days. If the need arises, I will order again from this company. Bob Hauff / Dayton, Ohio Read more

Replaced door latch and switch. Parts are plastic so you must know what you are doing to avoid breaking new parts. Videos were hard to find for my model - eventually I found a video that addressed a different problem but required disassembly of a washer cabinet similar to mine. I removed the control panel using a putty knife and unplugged the wire to the latch switch. Then I remove 3 screws securing the washer's top panel to the back panel. Using a rubber mallet, I gently knocked the top panel... Read more

It was very easy to fix after watching your video.. Read more

VERY EASY TO REPLACED OLD COVER-UNIT NEW COVER-UNIT. Read more