Kenmore Refrigerator 106.9650480 (1069650480, 106 9650480) Parts

It just popped right in after I received them promptly from you all! Read more

Replaced heater and defrost timer. All parts fixed perfectly with no modifications. I recevied my parts in 2 days!! Great service, great prices. I will return to your site when i need parts and advice again. Thank you!! Read more

My husband followed the instructions on the video. Read more

By purchasing two replacement thimbles and two hinge washers. Read more

Replacing the cold control solved the problem. While i was at it i also replaced the defrost timer and installed a new ice door. Read more

• Light not working

I saw your video on you tube and it seems very easy to do it my self, so I ordered the parts and I did it my self. It was very easy. Thank you for sharing with us on how to did it. One more thing, the parts arrived on the time they said it would come. Read more

Parts arrived as expected and installed easily. The price was excellent. This sites exploded parts diagram for my appliance made ordering the parts much easier than other sites. Read more

• Won't start
• Fridge too warm

Took access panel off the back of the refrigerator with 1/4 inch nut driver and found that the compressor was not running properly (humming and hot but not compressing). The compressor cooling fan was working as well as the fan in the freezer compartment. I fixed the same problem with another refrigerator by replacing the relay and start capacitor on the compressor. I pulled these two items from the compressor connector (gently pry the brown part from the comp terminals first and then the... Read more

Replaced it Read more

Followed the instructions that was sent with wheel . wasn't to difficult. maybe 15 to 20 minutes total repair time,start to finish. Read more

Looked up parts on internet using diagrams, ordered parts, they arrived in 2 days and installed them. Read more

Watched the video on how to replace. Ordered new roller, which was delivered in just a couple of days. Since the roller had broke, I was unable to roll out the refrigerator, so I tilted the refrigerator back and placed a small furniture slider under the roller frame to prevent gouging the wood floor. Then it was easy to slide out the refrigerator and replaced the roller as explained on the video. I had ordered a pin and bolt, just in case I would need to replace, but didn't need them. ... Read more

It was easy replace broken with new one snap on and off easy Read more

Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more

I had to cut down the length of the bar using a Dremel so that it would fit into the channels, it was originally too wide to fit into the fridge. One thing to note, only cut it as wide as the actual fridge; you can get it into the plastic shelf structure by sliding it too much into one side, and then guiding it into the other side. Read more

Ordered the part specific to my refrigerator... Received the shipped part super fast...Snapped it right into the frig...Including the opening of the box, the repair took less than 3 minutes... Read more