Kenmore Refrigerator 106.9658481 (1069658481, 106 9658481) Parts

I took the old shelf bar out the door and replaced it with the new one. Fit perfectly. Looks awesome. Read more

I ordered a new handle from Applisnce Parts Pros. It fit the refrigerator perfectly. I reused some of the old screws and ordered one new screw with a cover to attach the bottom of the handle. Now the refrigerator looks as good as new! Read more

It just popped right in after I received them promptly from you all! Read more

First replaced defrost timer. Iced up again after 2 weeks. Then replace the defrost heater. So far so good. Read more

Ordered a replacement and laid it inside refrigerator. Read more

By purchasing two replacement thimbles and two hinge washers. Read more

Replacing the cold control solved the problem. While i was at it i also replaced the defrost timer and installed a new ice door. Read more

• Light not working

I saw your video on you tube and it seems very easy to do it my self, so I ordered the parts and I did it my self. It was very easy. Thank you for sharing with us on how to did it. One more thing, the parts arrived on the time they said it would come. Read more

I tried unsuccessfully to find the model numbers for these two appliances until I called your company and your representative found them immediately and sent me the parts I think that the same day or the next day. Instructions were clear and easy and I installed them within moments, neither one was any trouble. Read more

Buy a new door shelf bar! I ordered it and two end caps (I didn't know the things existed) and shortly the package came from Appliance PartsPROS.com. In a matter of minutes I had a shiny new shelf bar and vavoom the refrigerator was as good as new! No more juice, milk, or soda cleanup on the floor! Thanks for your good service with the video, also. Read more

Followed the instructions that was sent with wheel . wasn't to difficult. maybe 15 to 20 minutes total repair time,start to finish. Read more

Looked up parts on internet using diagrams, ordered parts, they arrived in 2 days and installed them. Read more

Watched the video on how to replace. Ordered new roller, which was delivered in just a couple of days. Since the roller had broke, I was unable to roll out the refrigerator, so I tilted the refrigerator back and placed a small furniture slider under the roller frame to prevent gouging the wood floor. Then it was easy to slide out the refrigerator and replaced the roller as explained on the video. I had ordered a pin and bolt, just in case I would need to replace, but didn't need them. ... Read more

It was easy replace broken with new one snap on and off easy Read more

Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more

I had to cut down the length of the bar using a Dremel so that it would fit into the channels, it was originally too wide to fit into the fridge. One thing to note, only cut it as wide as the actual fridge; you can get it into the plastic shelf structure by sliding it too much into one side, and then guiding it into the other side. Read more