Kenmore Washer 110.24722300 (11024722300, 110 24722300) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP273556
Size: 10-16 x 5/8 inch.
Do-It-Yourself Stories from Customers like You
Console screws were rusty and the other screw was broken. Denis C. • Baltimore , MD • June 20, 2018
I used a screwdriver and removed all three screws and replaced them with ones I ordered from you. The job took less than ten minutes to complete.
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3360056
Used for the pressure switch.
Do-It-Yourself Stories from Customers like You
Broken lid switch Ari G. • State College , PA • June 01, 2015
Watched on line Video.
Only problem was in disconnecting wire "bus" connector from switch. I was unable to
remove connector without damaging it. I "jumped" connector to prove switch was faulty. This also allowed my wife to continue to do laundry while part arrived. I ordered a 3 circuit connector, but this was not the correct part. I ended up removing 3 wires from old broken connector and attaching them to new switch without a connector. Electrical tape did the trick. Not perfect...
Read more
More
$13.45
- Compare At:
-
$14.88
- You Save:
-
$1.43
Genuine Whirlpool part
By: Whirlpool
Part Number: WP354255
A small rubber bumper that cushions and protects appliance doors, drawers or panels to reduce noise and prevent hard contact. Replaces worn or missing bumpers to restore a snug, quiet close. What it does:
- Provides a soft buffer to stop doors or drawers from banging into the cabinet or frame
- Reduces vibration and rattling during operation
- Helps doors and panels sit properly when closed
- Simple, non-electrical part — no wiring or adjustment required
What's included:
Install notes:
- Inspect the mounting hole or surface; clean debris before installing
- Press the bumper into the hole or onto the surface until fully seated; use a blunt tool if needed for tight fits
- Disconnect power to the appliance first and follow OEM instructions
- Remove old adhesive before installing the new bumper
Do-It-Yourself Stories from Customers like You
Broken fill valve John N. • Tumwater , WA • July 14, 2015
The video associated with the part was easy to understand. The actual repair was easy - maybe 10 minutes. But getting the top casing of the washer fitted back over the base was a huge pain. That took 8 tries to finally get it locked in just right. The washer is 20+ years old though.
The parts were all exactly correct and fit perfectly. Shipping time was excellent. Parts arrived in about 2 days with "standard" shipping.
The washer works great now. This is the second major repair I've done...
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP54583
Right hand side. For screws use WPW10119828.
Do-It-Yourself Stories from Customers like You
Whirlpool washer David L. • Linn , MO • August 31, 2015
With the parts supplied from your company. The lady that took my order was good at her job. All the parts were correct and fit. I thank you for the service that recieved.
Read more
More
$19.50
- Compare At:
-
$23.20
- You Save:
-
$3.70
Genuine Whirlpool part
By: Whirlpool
Part Number: WP90016
Used from harness to top.
Do-It-Yourself Stories from Customers like You
A broken lid switch on my whirlpool stackable twin washer Joseph P. • Indialantic , FL • October 25, 2016
Fixing the problem was quite simple. First, I removed the lid assembly (thanks to the diagrams supplied by AppliancePartsPros.com!). Getting the back two screws out was very difficult because I couldn't see them from the front and I could not move the unit out of the enclosed space. After some trial and error, I located the screws which were 5/16 hex head screws and removed them with a MAGNETIC nut driver. (The magnet assures that the screw will not drop down into the mechanism). Second, I...
Read more
More
$9.49
- Compare At:
-
$10.44
- You Save:
-
$0.95
Genuine Whirlpool part
By: Whirlpool
Part Number: 285702
21-inch drain hose extension for washers. Extends existing drain hose when original is too short to reach standpipe. Includes clamp for secure fit.
Do-It-Yourself Stories from Customers like You
Drain hose too short and home depot fix leaked Sara B. • Liberty Hill , TX • August 21, 2015
Ordered a new drain hose and extension part. The prices including shipping were more reasonable than driving back and forth to the store just to piece meal parts together. Very frustrating. I ordered the parts that were specific to our washing machine, it took maybe 5 minutes to install, and everything fit perfectly.
Now we're washing again and no leaks!
Read more
More
$34.95
- Compare At:
-
$41.94
- You Save:
-
$6.99
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8546461
Fixes grinding noise or basket won't spin issues by disengaging the brake during spin cycles. Restores smooth operation when cam wears out or breaks.
Do-It-Yourself Stories from Customers like You
No spin every thing else worked made high speed ticking noise Anthony D. • Follansbee , WV • May 12, 2015
First I looked at the many you tube vids, and there are many. appliance parts pros pretty much shows you how to deal with the parts. I changed the brake shoes and the clutch assembly which also comes with the driver cam. I also changed the metal brake operating cam. I think that brake lockup or improper brake release was the problem that broke the plastic cam driver. This was the broken plastic part making all the ticking noise. I first changed the coupling on the motor but that wasn't bad. in...
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP285195
This is a small tube of silicone-based gasket sealer used to bond and seal gaskets during washer repairs. It creates a watertight seal between mating surfaces to prevent leaks around tub components or pump housings. Use this adhesive when replacing gaskets or resealing joints where the original sealant has deteriorated and water is leaking.
More
$64.70
- Compare At:
-
$76.99
- You Save:
-
$12.29
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3400818
Fixes loose or wobbly timer controls by securing the timer assembly to its mounting bracket. Simple 5-minute repair restores proper cycle operation.
Do-It-Yourself Stories from Customers like You
The cycles were off because the plastic on the part wore out. Cheryl S. • Shawnee , KS • February 24, 2018
Purchased this Whirlpool dial and watched you-tube. Just popped off cover and put on new part. Second time replaced in 7 years. Works great!
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP64208
Spin tube assembly with drive spacer, bearing, and shaft seals. Replace if washer leaks from bottom or basket doesn't spin properly. Verify fit.
Do-It-Yourself Stories from Customers like You
There was a center (tub) shaft seal leak in our Maytag washing machine. John W. • Manvel , TX • June 02, 2021
It was fairly difficult, but I watched and followed the Appliance PartsPros video and was able to get it done using the parts I purchased from APP. The leak has stopped (but I'm still watching after 5 loads).
Read more
More
$154.38
- Compare At:
-
$183.71
- You Save:
-
$29.33
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3946509
Includes suspension pads.
More
$97.47
- Compare At:
-
$115.01
- You Save:
-
$17.54
Genuine Whirlpool part
By: Whirlpool
Part Number: 350938
Color: Gray. Size: 13 oz. can. Used for coating the dryer drum interior. Acrylic appliance paint.
Do-It-Yourself Stories from Customers like You
Dryer drum completely wore off all coating Larry W. • Ubly , MI • July 01, 2016
Completely removed dryer drum cleaned surfaces ready for paint applied paint acquired from you it did a wonderful job with one can of paint will use for a while and acquire another can of paint for second coat thank you so much for your help the whirlpool dryer drum paint was exactly what it said it would do
Read more
More
$57.95
- Compare At:
-
$69.54
- You Save:
-
$11.59
Genuine Whirlpool part
By: Whirlpool
Part Number: WP54584
Washer lid hinge attaches the lid to the cabinet, allowing smooth opening and closing. Replace if cracked, rusted, broken, or causing lid misalignment.
Do-It-Yourself Stories from Customers like You
Whirlpool washer David L. • Linn , MO • August 31, 2015
With the parts supplied from your company. The lady that took my order was good at her job. All the parts were correct and fit. I thank you for the service that recieved.
Read more
More
$20.95
- Compare At:
-
$24.93
- You Save:
-
$3.98
Genuine Whirlpool part
By: Whirlpool
Part Number: WP62646
This clutch spring cap retains and protects the clutch spring in your washer's drive/clutch assembly, maintaining proper tension. Replacing a worn or missing cap helps the clutch engage smoothly and reduces slipping and noise during spin.
- Secures the clutch spring within the clutch assembly to prevent movement or dislodging
- Maintains correct spring preload for consistent clutch engagement
- Can help reduce clutch slip that appears as weak/no spin, slow spin ramp-up, or intermittent spinning
- Common signs of trouble: rattling or scraping near the drive, burning smell, or a visibly damaged/missing cap
What's included: 1 clutch spring cap Install notes:
- Unplug the appliance and shut off water before servicing
- Access the clutch per your model's service procedure; removing the gearcase/transmission and clutch may be required
- Carefully relieve spring tension and note the orientation of the spring and cap before removal
- Inspect the spring, clutch lining, and related hardware; replace any worn components during reassembly
Do-It-Yourself Stories from Customers like You
My washer wouldn't go into a spin cycle. Joshua P. • Cohutta , GA • April 18, 2021
I bought a clutch liner kit installed it in 5 minutes now it spins faster than ever.
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP62837
Knurled pin secures knobs or dials to control shafts in washers. Replace if the original is missing, worn, or damaged to stop loose or spinning knobs.
Do-It-Yourself Stories from Customers like You
Whirlpool shaking Willy P. • Victorville , CA • May 19, 2019
Weekend laundry became very noisy, our 1987 Whirlpool washer began doing a dance across the floor and the drum was banging into the inner cabinet. After doing some research and watching a few videos on Appliance parts pros website. I inspected the washer and noticed one leg the rubber coating disintegrated, decided to change all four legs, springs and lid switch. Hardest part of the job is getting the cabinet together. Ops check good.
Read more
More
$12.22
- Compare At:
-
$13.44
- You Save:
-
$1.22
Genuine Whirlpool part
By: Whirlpool
Part Number: 279868
This trim piece finishes and protects an opening or edge on your appliance's cabinet or console. Replacing a cracked or missing trim restores a clean, factory look and helps nearby components sit and operate as intended. What it does:
- Provides a clean, finished edge and covers sharp cabinet/console edges
- Helps keep adjacent parts aligned and secured around the opening
- Restores appearance when original trim is cracked, warped, discolored, or missing
- Common symptoms: loose or rattling piece, cosmetic damage, snagging edges, or poor fit of nearby parts
What's included:
Install notes:
- Disconnect power; if applicable, shut off gas or water. Wear cut-resistant gloves.
- Remove the existing trim by releasing clips or removing screws; note orientation and retain hardware.
- Transfer any reusable clips/inserts from the old trim to the new part.
- Align and snap/screw the new trim into place; do not overtighten.
More
$78.95
- Compare At:
-
$93.16
- You Save:
-
$14.21