Kenmore Dryer 110.6518721 (1106518721, 110 6518721) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: 279318
Includes screws and wire connectors. For the complete terminal block kit use 279320.
This part fixes the following symptoms
-
No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You
Loose wire in back caused a short and burned out plug insulator etc William W. • Pottsboro , TX • February 15, 2019
I ordered the parts through AppliancePartsPros.com. They were delivered the next day. I installed them and the dryer works great.
Read more
More
$58.43
- Compare At:
-
$68.95
- You Save:
-
$10.52
Genuine Whirlpool part
By: Whirlpool
Part Number: WP98234
U-type clip nut slides onto sheet metal panels to create threaded anchor points for screws. Replace if broken, missing, or worn during repairs.
Do-It-Yourself Stories from Customers like You
Broken hinge Ronald B. • Manchester , CT • October 21, 2019
Followed the video on how to replace the hinge I also replaced the dryer top locks while I had it open
Read more
More
$11.78
- Compare At:
-
$14.02
- You Save:
-
$2.24
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3394509
Low-friction bearing ring for smooth drum rotation. Replace when you hear squealing or scraping during cycles. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
The dryer made a horrible metal on metal scraping noise when running Anna D. • Santa Rosa , CA • January 28, 2017
We opened the dryer up with help from the videos on your site, and came to the conclusion that the rear drum-support rollers needed to be replaced. We thought the front bearing and seal looked a little past-it as well, so we ordered that and a new bearing ring to go with it, and a new dryer belt (just so we wouldn't have to get back into it again any time soon).
I ordered the parts (standard shipping) at 4:30 PST on Tuesday and they arrived before 3:00 the next day!
I replaced the front bearing...
Read more
More
$57.39
- Compare At:
-
$68.29
- You Save:
-
$10.90
Genuine Whirlpool part
By: Whirlpool
Part Number: WP660658
This part is a motor clamp. This is a genuine OEM part and has been sourced directly from the manufacturer. This part is intended to replace a deteriorated, damaged, or broken motor clamp on certain makes of indoor appliance models. Motor clamps are essential for properly securing the drive motor on various types of indoor appliances such as washers, dryers, and refrigerators. Without the use of a motor clamp, the drive motor is free to move around or become detached. This can easily cause serious damage to the equipment and prevent proper functionality. Proper tools are needed to replace this part and appropriate safety measures should be adhered to when working on any type of equipment. For accurate information on how and where to install this replacement motor clamp, specific manufacturer diagrams should be referred to.As an authentic replacement part, this motor clamp can be used on multiple different models of washers, dryers, refrigerators, and washer/dryer combos manufactured by Kenmore, Maytag, Whirlpool, and Amana. Please note that this motor clamp is a genuine part made of high-quality materials and is sold individually.
Do-It-Yourself Stories from Customers like You
The dryer motor stopped working. Kenneth M. P. • Saint Clair Shores , MI • December 05, 2021
I ordered a replacement motor from APP and installed it myself.
Read more
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: 279220
Includes two bumpers and two locking clips. You will use one or the other depending on hole size.
Do-It-Yourself Stories from Customers like You
Gas dryer did not heat and excessive lint inside the unit James C. • New Boston , MI • July 20, 2017
Our 19 year old Whirlpool dryer quit heating. After checking the thermal fuse, I found the ignitor electrically open. I bought an ignitor at a local store as there was a national holiday the next day and I did not want the dryer inoperative waiting several days for shipping. I can say AppliancePartsPros is MUCH cheaper for the identical Whirlpool genuine part. While changing the ignitor, I noticed there was an excessive amount of lint in the dryer, which was caused by worn drum seals. I ordered...
Read more
More
$12.32
- Compare At:
-
$14.66
- You Save:
-
$2.34
Genuine Whirlpool part
By: Whirlpool
Part Number: WP297092
This small retaining clip secures the door hinge in place so the door opens and closes smoothly and stays properly aligned. Replacing a worn or missing clip helps restore reliable hinge support and consistent door operation.
- Retains the hinge/hinge pin to prevent shifting or separation
- Helps maintain door alignment to avoid rubbing, sagging, or binding
- Replaces a clip that is bent, cracked, corroded, or missing
- Common signs it's needed: loose or wobbly door, difficulty closing, misaligned door, visible damaged/missing clip
What's included: 1 hinge clip Install notes:
- Unplug the appliance and, if applicable, remove items from the door to reduce weight
- Support the door before working on the hinge
- Remove any hinge cover/fasteners, swap the clip, and ensure it seats fully
- Reassemble and check door alignment and smooth operation
Do-It-Yourself Stories from Customers like You
Dryer no start George Larry B. • Niceville , FL • November 19, 2019
Removed and replaced start switch then motor, no joy. removed the timer for disassembly, found bad contact. soldered contact to the spring tab and assembled and installed the timer. All good now.
Read more
More
$11.95
- Compare At:
-
$14.22
- You Save:
-
$2.27
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8066217
Supports and pivots the hinged dryer top panel for service access. Replace if cracked, broken, or causing wobble, scraping, or alignment gaps.
Do-It-Yourself Stories from Customers like You
Would not spin Andrew M. • Long Island City , NY • December 18, 2015
Replaced belt and idler arm, just to be safe.
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP273556
Size: 10-16 x 5/8 inch.
Do-It-Yourself Stories from Customers like You
Console screws were rusty and the other screw was broken. Denis C. • Baltimore , MD • June 20, 2018
I used a screwdriver and removed all three screws and replaced them with ones I ordered from you. The job took less than ten minutes to complete.
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3390733
Vinyl door seal lines the dryer door perimeter to block air leaks and cushion closure. Replace when worn or cracked to restore a tight seal. Verify fit by model.
Do-It-Yourself Stories from Customers like You
The gasket on the dryer door needed replacing! Howard R. • Staten Island , NY • January 10, 2020
Ordered new gasket and adhesive!
Read more
More
$55.30
- Compare At:
-
$66.36
- You Save:
-
$11.06
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10044470
Right handed Hinge
Do-It-Yourself Stories from Customers like You
Dryer lint door was not properly connected Howard K. • Rye , NH • December 15, 2014
Popped in new hinge and door. Less than 5 minutes for entire repair
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10044480
Connects lint screen lid to dryer, enabling smooth opening and secure closing. Replace when bent, cracked, or broken to restore proper lid operation.
Do-It-Yourself Stories from Customers like You
Dryer motor Joseph S. • Lancaster , NY • January 17, 2015
I replaced it
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: 279771
This retainer clip secures a component in place to prevent movement and maintain proper alignment during appliance operation. Replacing a damaged or missing clip helps restore safe, reliable performance.
- Holds the mating part firmly to reduce vibration and noise
- Helps prevent intermittent operation caused by loose fitment
- Common fix when a component feels loose, rattles, or won't stay seated
What's included: 1 retainer clip Install notes:
- Disconnect power and shut off gas/water before servicing
- Note original clip orientation and location before removal
- Use needle-nose pliers to carefully release and install the clip
- Do not over-bend the clip; replace if deformed or fatigued
More
$9.70
- Compare At:
-
$11.54
- You Save:
-
$1.84
Genuine Whirlpool part
By: Whirlpool
Part Number: WP337388
Made by Whirlpool. Length 92-1/4 inch, width 1/4", 3 ribs.
Do-It-Yourself Stories from Customers like You
My dryer drum stopped circulatingt Doris S. • Oakfield , NY • February 29, 2016
The dryer is an older Kenmore and I went on the Sear's website to locate a replacement belt.
They listed many belts but gave no clear description of size or closeup pictures to determine ordering of the correct belt. I saw the Appliance Pros website in my search for the Sears website, so I thought it was worth a try.I'm so glad I did because I found my correct belt quite quickly, along with a clear description and close up picture - that set my mind at ease that I was ordering the correct...
Read more
More
$30.95
- Compare At:
-
$38.98
- You Save:
-
$8.03
Genuine Whirlpool part
By: Whirlpool
Part Number: 3400500
Replacement machine bolt for securing panels, brackets, and components in dishwashers, dryers, washers, and laundry centers. Restores fit if missing.
More
$12.13
- Compare At:
-
$13.34
- You Save:
-
$1.21
Genuine Whirlpool part
By: Whirlpool
Part Number: W11252547
Retaining clip secures panels and assemblies in dishwashers, dryers, and laundry centers. Replaces worn, broken, or missing clips to restore fit.
More
$14.56
- Compare At:
-
$17.33
- You Save:
-
$2.77
Genuine Whirlpool part
By: Whirlpool
Part Number: WP965173
Replacement 8-18 thread screw for securing panels, brackets, and trim on appliances. Replace worn, stripped, or missing screws to keep components aligned.
More
$7.94
- Compare At:
-
$8.06
- You Save:
-
$0.12