Kenmore Refrigerator 363.9512483 (3639512483, 363 9512483) Parts
Genuine Ge part
By: Ge
Part Number: WR50X55
Freezer icing up or fridge not cooling? The defrost thermostat regulates defrost cycles. DIYers report straightforward replacement in under an hour.
This part fixes the following symptoms
-
Freezer not defrosting
-
Freezer section too warm
-
Fridge too warm
See more...
Do-It-Yourself Stories from Customers like You
Freezer iced up behind panel refrigerator not cooling Lisa S. • Camanche , IA • October 08, 2016
Ordered a ge thermostat part . Took everything out of freezer , unscrewed panel and took the plate out. Used a hair dryer to defrost ice. Took out old part and installed new part. Everything is working just fine!!! Used a meter to test old/bad part and indeed it was dead.
Read more
More
$15.33
- Compare At:
-
$30.42
- You Save:
-
$15.09
Genuine Ge part
By: Ge
Part Number: WR62X26536
This armature kit is the moving plunger and linkage operated by the dispenser solenoid. It opens and closes the ice chute door during dispensing and helps it seal when idle to reduce frost and warm-air leaks.
- Converts the solenoid's electrical action into mechanical movement for the dispenser ice chute door
- Helps maintain a proper seal to limit frost and moisture around the dispenser
- Typical symptoms: ice won't dispense; chute door won't open/close; frost/ice buildup at the chute; loud buzzing or clicking from the dispenser area
- Wear or sticking of the armature/spring can hinder movement and affect dispenser operation
What's included: 1 armature kit Installation notes:
- Unplug the refrigerator and shut off water to the dispenser before servicing
- Access the dispenser mechanism in the door; remove trim/control panel per your model's service information
- Note the orientation of the armature, spring, and linkage; transfer components one-for-one to the new kit and secure hardware
- Verify the solenoid plunger moves freely, reassemble, restore power, and test dispenser operation
Do-It-Yourself Stories from Customers like You
Water was overflowing out of the ice maker during fill process and freezing into a block of ice! Steven B. • Arlington , TX • March 17, 2015
Replaced the water supply valve...boom!
Read more
More
$57.32
- Compare At:
-
$68.21
- You Save:
-
$10.89
Genuine Ge part
By: Ge
Part Number: WR23X10300
Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.
Do-It-Yourself Stories from Customers like You
Power cord needed to be replaced Jorge V. • Tucson , AZ • November 14, 2015
Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR1X5278
Secures refrigerator wiring to prevent chafing and vibration noise. Replace when damaged or missing to keep harnesses organized. Confirm fit by model.
More
Genuine Ge part
By: Ge
Part Number: WZ4X241D
Includes 12 screws. Size: 8-18 ab.
Do-It-Yourself Stories from Customers like You
We didn't have a power cord for our dryer Heather B. • Dulce , NM • October 27, 2018
Ordered the cord through appliance parts pros, with additional screws and it works! Yay after waiting months and everywhere was out. Thank you.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR01X10623
Replacement 8-18 x 9/16 machine screw for securing panels, brackets, and internal components. Needed when fasteners are stripped, missing, or worn.
Do-It-Yourself Stories from Customers like You
Ice maker internal door not closing John M. • St. Augustine , FL • January 12, 2016
Originally replaced the door and spring but it still would not close. This time, replace the solenoid and it works great!!!
Read more
More
$14.95
- Compare At:
-
$17.79
- You Save:
-
$2.84
Genuine Ge part
By: Ge
Part Number: WR2X4990
Hardware fasteners for securing refrigerator door panels and components. Includes screws, nuts, and washers for assembly. Replace missing or stripped pieces.
More
$8.95
- Compare At:
-
$12.70
- You Save:
-
$3.75
Genuine Ge part
By: Ge
Part Number: WR2X7942
Support bracket that holds the cradle switch in your refrigerator. Replace if the original is cracked, broken, or missing to properly secure the switch.
More
$1.95
- Compare At:
-
$4.68
- You Save:
-
$2.73
Genuine Ge part
By: Ge
Part Number: WR86X25269
The R134 Drier is an OEM part for GE refrigerators. This component plays a critical role in the refrigeration system by removing moisture and contaminants from the refrigerant, ensuring efficient cooling and preventing damage to other parts of the system. It helps maintain the purity and effectiveness of the refrigerant as it cycles through the system.
You should replace the R134 drier if it becomes clogged or damaged. Common causes of a bad drier include wear and tear over time, exposure to moisture, or contamination from other failing components in the refrigeration system.
Symptoms of a bad R134 drier include:
- Reduced cooling efficiency
- Frost buildup on the evaporator coils
- Unusual noises from the refrigeration system
- Increased energy consumption
- Refrigerator not maintaining the set temperature
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
More
$64.74
- Compare At:
-
$76.39
- You Save:
-
$11.65
Genuine Ge part
By: Ge
Part Number: WR01X10618
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
Do-It-Yourself Stories from Customers like You
Ice dispenser wouldn't dispense ice Chris K. • Felton , DE • April 29, 2025
The auger gearbox shaft had a spot that was stripped of threads which prevented the auger drive from spinning the ice down the chute. I replaced the auger motor/gearbox assembly, the auger drive as it had to be cut off the shaft, and the 3 mount bolts that hold it all in place. Whole job took 30 minutes from start to finish which included cutting off the drive bracket.
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR1X1367D
Includes 12 retainer rings.
Do-It-Yourself Stories from Customers like You
A fin on the plastic auger broke off and needed to be replaced John M. • Massanutten , VA • August 08, 2015
I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went...
Read more
More
$13.79
- Compare At:
-
$16.41
- You Save:
-
$2.62
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR57X57
Nut for 1/4 inch tubing.
Do-It-Yourself Stories from Customers like You
Frigidaire refrigerator model FRS3HR5HMB5 having issues with ice buildup around the evaporator fan have had similar issue for three to four years Keith C. • Cypress , TX • November 12, 2018
Changed the Frigidaire Icemaker Fill Tube Part # 241796405 (AP5671747) about a week ago and so far the Frigidaire Refrigerator seems to work fine. Did not use other ordered parts. Recently ice formed around internal evaporator fan and it started making loud noise when then fan and compressor, etc were running. A long winded history noted below if interested:
I have been fighting with this Frigidaire Refrigerator for about 3 to 4 years, started out with the evaporator fan making noise when ice...
Read more
More
$7.37
- Compare At:
-
$8.36
- You Save:
-
$0.99
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X7309
This solenoid saddle is a small mounting bracket that secures a refrigerator solenoid in the correct position. By preventing movement and misalignment, it helps the linked mechanism engage smoothly and consistently.
- Secures the solenoid to its housing or frame to prevent shifting
- Maintains proper alignment for reliable actuation
- A worn or broken saddle can cause buzzing/chattering and intermittent operation
- Restores stable mounting to help the connected mechanism work correctly
What's included: 1 solenoid saddle Install notes:
- Disconnect power; shut off water supply if working near water lines
- Access the solenoid assembly and note the original saddle's orientation
- Transfer the solenoid into the new saddle and reuse existing fasteners/clips
- Smooth operation before reassembling panels
Do-It-Yourself Stories from Customers like You
Ice dispenser crushing ice only no cubes Eric W. • Copper Canyon , TX • June 27, 2014
Easy fix once I found the problem. Broken solenoid sleeve. Part cost $2.58 + shipping. 10 minute repair.
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR17X10273
Ice storage bin holds and stores ice produced by the refrigerator's ice maker so cubes are ready for dispensing and stay contained. Replaces cracked, broken, or missing bins to restore normal ice storage and delivery. What it does:
- Collects and stores ice made by the ice maker so cubes are available for dispensing.
- Guides ice toward the dispenser/auger area and helps prevent ice from spilling into the freezer.
- Restores proper ice containment when the original bin is cracked, warped, or missing.
- Helps reduce ice clumping and jams caused by broken or misaligned storage containers.
What's included: One ice storage bin. Install notes:
- Disconnect power to the refrigerator before removing or installing the ice bin.
- Remove shelves or drawer(s) as needed for access; lift out the old bin carefully to avoid damaging the ice maker or dispenser components.
- Align tabs and guides on the new bin and slide into place without forcing; listen for the bin to seat properly.
- After installation, restore power and run the ice maker/dispenser through a test cycle; discard the first batch of ice after reinstallation.
Do-It-Yourself Stories from Customers like You
The problem was abuse Bruce S. • Tequesta , FL • April 12, 2019
I fixed it by getting the model and serial number written down, made a call to appliance pros (as I usually do) told them the model and serial numbers, they expertly looked up the unit, told her which parts needed replacing. She took my credit card info and sent me the parts. Simple, they were exact and fit perfectly. What ever appliances I need to fix, you guys are my source. Bosch, GE, whatever, you have always helped me get the replacement part. Looking below, on this repair, no tools at all.
Read more
More
$42.41
- Compare At:
-
$50.47
- You Save:
-
$8.06
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR1X1366D
Includes 12 washers.
Do-It-Yourself Stories from Customers like You
A fin on the plastic auger broke off and needed to be replaced John M. • Massanutten , VA • August 08, 2015
I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went...
Read more
More
$32.95
- Compare At:
-
$39.21
- You Save:
-
$6.26
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X7905
Seals the ice bucket to prevent spills, frost buildup, and water pooling. Replace when ice shifts or water collects. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
The augor in the ice maker was rusty Angie K. • Greenwich , CT • November 15, 2015
Changed the part with SS part.
Read more
More
$10.07
- Compare At:
-
$11.94
- You Save:
-
$1.87
Out Of Stock
Usually ships within 4 - 14 days