Kenmore Dryer 417.81052001 (41781052001, 417 81052001) Parts

Secures the fan housing to its mounting points. Replace if the clip is broken, missing, or worn to eliminate rattles and prevent air leaks in your dryer.

This is a replacement pan-head, locking screw used to secure the top bracket on compatible Frigidaire appliances. It provides a reliable fastener that helps keep the top bracket and panels held firmly in place. What it does:

• Secures the top bracket to the cabinet or chassis to prevent bracket movement or rattling
• Restores proper alignment of top panels and trim that may be loose or sagging
• Uses a locking feature to resist loosening from vibration
• Pan head design provides a low-profile, finished appearance once installed

• One screw as shown

• Use the matching #8-32 driver or bit and tighten until snug; avoid over-torquing to prevent stripping
• Turn off power and remove panels as needed before accessing the bracket area
• Replace only with the same size and thread type to ensure secure fit
• Replace all related screws for even support

White plastic dome plug insert for dryer. Covers exposed holes on dryer cabinet where pedestal or stacking kit was removed. Replaces missing or broken plugs.

Control board mounting bracket for dryers. Secures the electronic control board to the dryer frame. Replace if bracket is cracked, bent, or missing.

White top panel for dryers. Covers the control area and main housing. Replace when cracked, chipped, discolored, or damaged for a complete exterior refresh.

White and gray timer control knob for dryers. Replaces cracked, broken, or missing knobs. Installs on the control panel to operate the timer dial.

The Motor is an OEM part for Frigidaire dryers. It is responsible for driving the drum rotation in the dryer, allowing for the tumbling and drying of clothes. It converts electrical energy into mechanical motion, providing the necessary power to spin the drum and circulate air for efficient drying.

Causes of a faulty dryer motor can include wear and tear over time, electrical malfunctions, or physical damage. These factors can result in issues such as the drum not spinning, unusual noises during operation, or the dryer not heating properly.

Symptoms of a bad dryer motor may include:

• The drum not rotating or spinning
• Unusual grinding or squealing noises while the dryer is in use
• Dryer not generating heat or insufficient drying performance

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

The Lower Front Felt Seal is an OEM part for Frigidaire dryers. This seal prevents hot air from escaping the dryer drum, ensuring optimal drying efficiency and preventing heat loss. It also helps reduce noise and vibration during operation.

Causes of a faulty lower front felt seal can include wear and tear over time, damage from foreign objects or excessive heat, or adhesive failure. These factors can result in air leakage, increased drying time, or excessive lint buildup.

Symptoms of a front felt seal may include:

• Air leakage around the dryer door or front panel
• Excessive lint accumulation near the dryer opening
• Unusual noises or vibrations during the operation

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Note: For the Hi-Temp Adhesive, order part number 5308027429. Additional parts to check are the rear drum bearing kit 5303281153 and the front felt glide assembly 5303937139.