Kenmore Refrigerator 596.75939300 (59675939300, 596 75939300) Parts

I had verified that the water supply was healthy, so it was either the icemaker unit or the water valve. I replaced the icemake first, based on a the pareto showing it was the culprit for most other people, but it didn't help. That replacement was straightforward; the hardest part was reaching all the way back to unclip the wiring harness since I am too lazy to totally empty the bottom freezer and remove the door. So the next step was the water valve. The hardest part of this was pulling the... Read more

Replaced the ice level arm Read more

Had to take the back cover off. It was very tight to remove the fan that sat in the drip pan but did get it off, was able to apply the same level of cursing and got the new pan installed, installing the drain tube was a breeze. Found the parts price very reasonable. Hoping the Whirlpool redesigned the pan so I won't have to do it ever again. I was surprised at how bad the quality of their original part was. Probably saved myself $150.00 on buying the part and doing it myself Read more

Thank you to everyone who entered comments, especially about the "Clicking" sounds when it was trying to turn on the compressor. I did not notice them at first, but then heard them and was confident that one of these parts (or both) had a problem. In my case, I have custom cabinets around the sides of the refrigerator and hardwood floors in the kitchen so I put down some cardboard when the rollers would need to go at an angle due to a center island in the way. (I would rather do this myself... Read more

Replaced icemaker and shutoff arm. Easy project. Read more

• Ice maker dispenses too much ice
• Leaking
• Ice maker not making ice

Watched online video and worked along - it was easy and quick - I was amazed! Read more

Took it out, inventoried the damaged parts and ordered replacements. Everything is back together except the trim panel, which is back-ordered. When it comes in, I will replace it as well. Read more

Purchased a new one Read more

Maytag Dishwasher (about 5 years old). Some of the buttons had stopped functioning. Then the Start button began choosing whether or not to work. Eventually it would not start at all. Upon removing the control panel, the first thing I noticed was that the brackets that hold the two lower screws were broken. (So this was the reason that the door was so hard to open from the time it was new.) I trouble shot the thermal fuse, the door-latch switches, and inspected the control board trying to find... Read more

Removed old gasket from groove then pushed new one into the cleaned groove. Took 5 minutes. Read more

Replaced those two items listed above, please continue reading! I'm a mechanic by trade, so I have the basics. And what made this job easy? Appliance parts pros! very easy access to Part numbers and Diagrams, Online help, Customer service, and the list goes on. You will see several other sites, However! Wouldn't it be nice, knowing the above? Go no further! If you get stumped on anything during your Maintenance or Repair, They will Help. Read more

Really simple fix no tools required. Simply pulled the old out and install the new one in . Not hard at all. Read more

Replaced the water tube that went from the plastic tubing to the ice cube tray. Found that even though it was the same exact length as the original, there was only an extremely small gap from the end of the tube to a splash board. This may have been the root cause of my problems. Read more

Easy....contacted AppliancePartsPros.com, ordered new glass and replaced glass. No tools required. Read more

Ordered part from AppliancePartsPros.com and received it 2 days later. Put the part in, fit like a glove, water and ice cube maker working flawlessly again with no leaks. Thanks. Read more

The damper Cover snapped on in less then a second. Perfect fit! Read more