Kenmore Dishwasher 665.13173K701 (66513173K701, 665 13173K701) Parts

Replacement silverware basket for your dishwasher's lower rack. Organizes forks, knives, and spoons during wash cycles. Needed when original is cracked or broken.

Secures interior panels and trim to prevent vibration and movement. Replace when clips break or lose grip. Verify fit with your model number.

Directs airflow in your dishwasher's vent system. Replace if cracked, discolored, or blocking proper ventilation. Confirm fit with your model number.

Replace a cracked, bent, or worn right-hand door hinge on your dishwasher. Restores proper door alignment and smooth opening/closing operation.

Console not responding or display is dark? This interconnect board restores signal routing between your dishwasher's console and main electronics.

Dispenser won't latch or close? This detergent dispenser releases soap at the right time. Moderate DIY repair requiring inner door panel removal.

The Power Cord Kit is an OEM replacement part for Whirlpool dishwashers. It is a 3-prong grounded, 16-gauge cord that includes all the hardware needed for installation. Includes all hardware needed for installation.

Causes of a bad power cord can include normal wear and tear over years of use, accidental impacts or cuts to the wiring, or improper installation that damages components.

Symptoms of a bad power cord include:

• The dishwasher not turning on or completing cycles
• Warm or hot power cords during operation
• Frayed, cracked, or exposed copper wiring

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air, and some Kenmore models.

Insulation pad that fits behind dishwasher panels to restore thermal protection and reduce noise. Replace if damaged, missing, or rattling occurs.

Secures water inlet tubing to create a leak-resistant seal. Replace if cracked, stripped, or unable to hold the line securely. Confirm fit with your model.

Dishwasher won't start or stops mid-cycle? This door switch detects when the door is closed to allow operation. Common DIY fix for no-start issues.

This manifold is the OEM gas valve assembly that routes propane or natural gas from the regulator to the oven and burner valves so the appliance can ignite and heat properly. Designed as a direct-replacement service part. What it does

• Channels gas from the regulator to individual burner/oven valves so each burner can ignite.
• Replaces a worn or damaged manifold that can cause weak or no ignition.
• Addresses symptoms such as burners that won't light, oven failing to heat, or inconsistent flame across burners.
• Works with the appliance's existing regulator and control valves when installed correctly.

• Turn off gas supply and electrical power before attempting removal or service.
• Inspect fittings and gaskets; replace any damaged seals to prevent leaks.
• After installation, perform a gas-leak test and verify proper ignition and flame patterns.

Upper rack cup shelf for dishwashers. Snaps into rack clips to hold cups securely. Replace when cracked, rusted, broken, or missing from your rack.

Fine mesh screen filter sits in the dishwasher sump to trap food particles and debris, protecting the pump and wash system. Replace when clogged or damaged. Confirm fit with your model number.

Replaces broken, melted, or missing lower rack insert. Secures and separates dishes in the lower rack. Snaps into place without tools needed.